Page 1
www.fisher-price.com
Press the button
for fun music!
H9458
Instructions
Musical Zebra
Musical Zebra
™
™
Page 2
Consumer Information
• Please keep this instruction sheet for future reference, as it contains
important information.
• Requires three (LR44) alkaline button cell batteries (included).
• Adult assembly is required for battery replacement.
• Tool required for battery replacement: Phillips screwdriver (not included)
Visit us on line at www.service.mattel.com
Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers
using TTY/TDD equipment, please call 1-800-382-7470.
Write to us at: Fisher-Price® Consumer Relations, 636 Girard Avenue,
East Aurora, New York 14052.
Before First Time Use
CAUTION
Please keep small parts such as the
plastic tabs out of children’s reach.
Throw the plastic tab away.
Note: A plastic tab was attached to the toy for in-store demonstration
purposes. While the tab may have already been removed, check the
bottom of the toy to be sure. If the plastic tab is still attached, pull and
remove the tab from the toy. Throw the plastic tab away.
Recycle Information (U.S.A. ONLY)
If your product contains replaceable button cell batteries, please remove and
recycle the battery(ies). If the batteries in your product are not replaceable,
please recycle your product.
•
Visit your nearest recycling center. For the location of the nearest recycling
center, visit us online at www.service.mattel.com.
•
If a recycling center is not available in your area, contact us for a pre-paid
mailing label. Visit us online at www.service.mattel.com or call us
toll-free, 1-800-432-5437.
Page 3
Battery Replacement
For best results, use only alkaline
batteries, for longer battery life.
1.5V x 3
LR44 or Equivalent
SHOWN ACTUAL SIZE
Battery Compartment Door
• When sounds from this toy become faint or stop, it is time for an adult
to change the batteries!
• Locate the battery compartment on the back of the toy.
• Loosen the screw in the battery compartment door with a Phillips
screwdriver. Remove the battery compartment door, and throw
exhausted batteries away.
• Insert three, new, button cell (LR44) alkaline batteries, as indicated
inside the battery compartment.
• Replace the battery compartment door and tighten the screw with a
Phillips screwdriver. Do not over-tighten.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause
a chemical burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be
charged under adult supervision.
Page 4
Care
• Wipe the toy with a clean cloth dampened with a mild soap and
water solution.
• Do not immerse the toy.
FCC Note (United States Only)
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga,
Ontario L5R 3W2; www.service.mattel.com.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500303; www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria
3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China.
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.
©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA H9458pr-0920
Loading...