Fisher-Price H7181 User Manual
www.fisher-price.com
H7181
Product features and decorations may vary from picture above.
WARNING
IMPORTANT! KEEP INSTRUCTIONS
FOR FUTURE REFERENCE.
• Please read these instructions before assembly and use of
this product.
• Adult assembly is required.
• Tool needed for assembly: Phillips Screwdriver
(not included).
• Requires four “C” (LR14) alkaline batteries for operation
(not included).
• Weight Limit: 9 kg (20 lbs).
IMPORTANT! The maximum weight limit for this product is
9 kg (20 lbs). If your child weighs less than 9 kg (20 lbs),
but is really active and appears to be able to climb out of the
swing, immediately discontinue its use.
2
WARNING
To prevent serious injury or death
from falls and being strangled in
the restraint system:
• Always use the restraint system.
• Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 kg, 20 lbs).
• Never leave the child unattended.
• It is dangerous to use this product
on an elevated surface.
Seat Back Tube
Parts
Pad
Lower Swing Arm Assembly
(with Restraint System)
CAUTION
This package contains small parts
in its unassembled state.
Adult assembly is required.
Frame
2 Frame Tubes
Base Tube
Front Tube
3 Link Toys
2
2
#6 x 1.9 cm Screw - 4
Shown Actual Size
NOTE: Tighten and loosen all screws
with a Phillips screwdriver. Do not
over-tighten the screws.
Assembly
IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use
if any parts are missing or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts.
Press Button on Front Tube
Press Button on
Lower Frame Tube
Upper Frame Tube
Rubber Feet Down
3
1
• Rotate the upper frame tube until it "snaps" into an upright
position, as shown.
Short Tubes
Press Buttons on Base Tube
2
• While pressing the button on the base tube, insert it into a
short tube on a frame tube.
• Push the base tube until it “clicks” into place.
• While pressing the button on the other end of the base tube,
insert it into the short tube on the other frame tube.
• Push the base tube until it
Hint:
You may need the help of another adult to hold the frame tubes
while you assemble the base tube to them.
“clicks”
into place.
�• Position the front tube so that the rubber feet are
the surface.
• While pressing the button on the lower frame tube, insert it
into an end of the front tube. Continue to insert the lower
frame tube into the front tube until you
• While pressing the button on the front tube, insert it into the
end of the lower frame tube. Continue to insert the front tube
into the lower frame tube until you
hear a "click".
hear a "click".
flat on
3
2
3
Assembly
Upper
Frame
Tube
Frame
Upper
Frame
Tube
4
Front Tube
• Pull the front tube to be sure it is secure to each lower
frame tube.
Frame
Press Button
on Upper
Frame Tube
6
• Check to be sure the upper frame tubes are secure in the
frame. If you can remove the upper frame tubes from the
frame, you have not properly inserted the tubes into the
frame. Repeat Assembly step 5.
5
• Insert the upper frame tubes into the frame until you hear a
on both sides.
"click"
2
4
Loading...