Fisher-Price H6372 User Manual

Stride-to-Ride

Learning Walker

Please keep this instruction sheet
for future reference, as it contains
important information.

Maximum weight:
42 lbs. (19 kg).
For ages between
9 months and
3 years.

Requires three “AA”
batteries (included).

Adult assembly is required.

Tool required for
battery replacement:
Phillips screwdriver
(not included).

H6372

™

www.fisher-price.com

Before Use

CAUTION

Please keep small parts such as

plastic tabs out of children’s reach.

Throw the plastic tab away.

Note: A plastic tab is attached to the toy for in-store demonstration
purposes. While the tab may have already been removed,
check the dashboard to be sure. If the plastic tab is still attached,
pull and remove the tab from the toy. Throw the plastic tab away.

Parts

FCC Note

(United States Only)

Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician
for help.

Note: Changes or modifications not expressly approved by
the manufacturer responsible for compliance could void the
user's authority to operate the equipment.

Base

Front Wheels

Dashboard

2 Caster Wheels

Hood

Not Shown: Label Sheet

2

3 Shape Sorter Blocks

Front Wheels

1

Bottom View

Assembly

Dashboard

3

• Place the base upside down on a flat surface.

• “Snap” the front wheels to the underside of the base,

as shown.

Caster Wheels

2

• Insert and “snap” the dashboard into the base, as shown.

Hint: This may require some force.

Pull up on the dashboard to be sure it is secure to the base.

•

Hood

4

Insert and “snap” the caster wheels into the base, as shown.

•
Hint: This may require some force.

• Pull up on the caster wheels to be sure they are secure to
the base.Turn the base over.

• Fit the peg on the left side of the hood into the matching
hole in the dashboard.

• Press to “snap” the other peg into the dashboard.

3