Fisher-Price H5924 User Manual

Neck

Ta il

Body

Assembly

• Slide the tail onto the body, as shown.

• Slide the neck onto the body,
as shown.

• "Snap" the three toys into the
assembly.

1

Parts

www.fisher-price.com

H5924

Instructions

Please keep this instruction sheet for future reference,

as it contains important information.

Requires three "AA" (LR6) alkaline batteries (not included).

Adult assembly is required.

Tool required for assembly: Phillips screwdriver (not included).

Drop & Roar

™

Dinosaur

2

• Turn the assembly around.

• Insert two screws into the assembly
and tighten the screws.

#6 x 11/2" Screw - 2

Shown Actual Size

Note: Tighten or loosen all screws
with a Phillips screwdriver. Do not

over-tighten the screws.

3 Toys

3

This toy contains small parts in its unassembled state.

Adult assembly is required.

CAUTION

• "Snap" the head onto the assembly,
as shown.

4

Head

4 Balls

Neck

Ta il

Body

Music, Lights and Rolling Action!

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.

©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.

PRINTED IN MEXICO H5924pr-0920

In exceptional circumstances, batteries
may leak fluids that can cause a
chemical burn injury or ruin your toy.
To avoid battery leakage:

• Do not mix old and new batteries
or batteries of different types: alkaline,
standard (carbon-zinc)
or rechargeable (nickel-cadmium).

• Insert batteries as indicated inside

the battery compartment.

• Remove batteries during long
periods of non-use. Always remove
exhausted batteries from the toy.
Dispose of batteries safely. Do not
dispose of batteries in a fire. The
batteries may explode or leak.

• Never short-circuit the battery
terminals.

• Use only batteries of the same or
equivalent type, as recommended.

• Do not charge non-rechargeable
batteries.

• Remove rechargeable batteries from
the toy before charging.

• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.

• Locate the power/volume switch on the top of the toy.

• Slide the switch to on with low volume ; on with high volume or off .

• Drop balls into the holes or down the ramps for fun music, lights and
dino sounds.

Battery Safety

Information

Battery

Installation

• Locate the battery compartment on
the back of the toy.

• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.

• Insert three "AA" (LR6) alkaline
batteries, as indicated inside the
battery compartment.

Hint: We recommend using alkaline
batteries for longer life.

• Replace the battery compartment door
and tighten the screws with a Phillips
screwdriver. Do not over-tighten.

• When lights or sounds from this toy
become faint or stop, it’s time for an
adult to change the batteries!

1,5 V x 3

“AA” (LR6)

Shown Actual Size

Battery Compartment Door

Power/Volume

Switch

Back View

Visit us on line at www.service.fisher-price.com.

Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437, 8 AM - 6 PM EST
Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382-7470.

Write to us at: Fisher-Price® Consumer Relations, 636 Girard Avenue,
East Aurora, New York 14052.

Consumer Information

• Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do
not immerse this toy.

• This toy has no consumer serviceable parts. Do not take this toy apart.

Care

Note: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for help.

Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.

FCC Note (United States Only)

For countries outside the United States:

CANADA: Questions? 1-800-432-5437 . Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2;

www.service.mattel.com.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303.

www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.

Consumer Advisory Service 1300 135 312.

NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.

Peek-a-boo

door

Balls roll out

the chute

Dino mouth

opens as balls

roll out

Wiggly friend

Colorful lights

Spinning

butterfly