Please keep this instruction sheet for future reference,
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AAA” (LR03)
batteries (not included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver (not included).
as it contains important information.
Requires three “AAA” (LR03)
batteries (not included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver (not included).
alkaline
H5341
1
One-Time Assembly
CAUTION
This toy contains small parts in
its unassembled state.
Adult assembly is required.
Upper Skull
Lower Skull
Frame
3
#4 x
/8" Screw - 8
Shown Actual Size
• Fit the pegs in the upper and lower skull into the holes
in the frame.
3
• Insert eight #4 x
and tighten. Do not over-tighten.
/8" screws into the back of the frame
2
Battery Installation Battery Safety Information
1.5V x 3
“AAA” (LR03)
BOTTOM VIEW
• Locate the battery compartment on the skull assembly.
• Loosen the screw in the battery compartment door
with a Phillips screwdriver. Remove the battery
compartment door.
• Insert three, "AAA" (LR03) alkaline batteries,
as indicated inside the battery compartment.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the
screw with a Phillips screwdriver. Do not over-tighten.
• If this product begins to operate erratically, you will
need to reset the electronics. Slide the power switch
off and then back on.
• When sounds or lights from this toy become faint or
stop, it’s time for an adult to change the batteries!
• Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice
and facilities (Europe only).
In exceptional circumstances, batteries may leak fluids
that can cause a chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Dispose of batteries safely. Do not dispose of this
product in a fire. The batteries inside may explode
or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
3