• Please keep this Owner’s Manual for future reference, as it contains
important information.
• Adult assembly is required. You may need the assistance of another adult to
complete assembly.
• Do not use Shot Block™ Basketball in a room with direct sunlight. Do not use
Shot Block™ Basketball outdoors.
• Tool required for assembly: Phillips screwdriver (not included).
• You may find it helpful to use an adjustable wrench to hold the M5 lock nuts while
tightening the M5 bolts.
• Requires four, “C” (LR14) alkaline batteries (not included) for operation. Each fresh set of
batteries should last approximately 15 hours (of continuous use).
• Please identify all parts before assembly and save all packaging material until assembly
is complete to ensure that no parts are discarded.
• If you experience a problem, or are missing a part, please visit us on-line at
www.service.fisher-price.com. Or call, 1-800-432-5437 rather than return this
product to the store.
• Use only the basketballs supplied with this product. Do not use with regulation size
(actual) basketballs.
3
PARTS
PARTS
1 Backboard
2 Chute
3 U Tube
4 Door Clip
5 2 Pivot Tubes
(Left and Right)
Part not shown: Label Sheet
1
2
4
5
3
4
6 2 Tubes
(Left and Right)
7 2 Basketballs
8 Handle
9 2 Hinge Tubes
(Left and Right)
7
6
8
Tip: All fasteners shown actual size.
M5 x 23 mm Bolt – 8
9
M5 Lock Nut – 8
#8 x 1" Screw – 4
Note: Tighten and loosen all bolts and screws with a
Phillips screwdriver. Do not over-tighten the fasteners.
We’ve included extra fasteners for your convenience!
5
BATTERY INSTALLATION
BATTERY INSTALLATION
Tip: We recommend the use of alkaline batteries for longer battery life!
1.5V x 4
"C" (LR14)
Battery
Compartment
Door
• Loosen the screws in the battery compartment door on the back of the backboard.
Remove the battery compartment door.
• Insert four "C" (LR14) alkaline batteries.
• Replace the battery compartment door and tighten the screws.
Tip: When sounds, lights or movement become faint, sluggish or stop, it’s time
for an adult to change the batteries!
SHOWN ACTUAL SIZE
BATTERY SAFETY INFORMATION
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury
or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely. Do not dispose of batteries in a fire. The
batteries may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged
under adult supervision.
6
DECORATION
™
™
DECORATION
4
1
5
3
2
6
• Before applying the labels, wipe all
surfaces with a clean, dry cloth to
remove any dust or oils.
• Apply the labels as indicated in the
illustrations.
7
8
9
10
14
15
16
11
12
13
6
19
17
7
18
ASSEMBLY TIP
ASSEMBLY TIP
• When tightening bolts in tubes, you will need to press the lock nut into the opposite side
of the tube (the hex hole). Place your thumb on the lock nut while tightening bolt with a
Phillips screwdriver.
Tip: You may want to use an adjustable wrench to hold the lock nut in place.
8
U Tube
ASSEMBLY
ASSEMBLY
Backboard
Grooves
STEP 1
• Place the backboard face down on a flat surface.
• Fit the ends of the U tube into the grooves in the bottom of the backboard.
9
ASSEMBLY
ASSEMBLY
STEP 2
• Insert four #8 x 1" screws into the U tube and tighten.
10
Door Clip
Slot
STEP 3
• Insert the door clip into the slot in the top of the backboard until it "snaps" into place.
11
Loading...
+ 25 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.