CLEANING DARTS
5
ATTACHING TARGETS
4
Peel backing off target before sticking
it to surface.
Do not stick target to walls
✖
or furniture as it may cause
damage to the surface.
REMOVING DARTS
6
Keep one hand pressed on target, hold
dart by the tip and gently peel dart off.
Dust, dirt, and other debris can cause
darts to lose their adhesiveness.
To clean darts, rinse darts’ tips with
tap water or use tape to remove
excess debris.
NOTE: Dry darts before using again.
REPLACING TARGETS
7
& SHIELDS
CONTENTS
1
MAD SLAMMER™ BLASTER
INSTRUCTIONS
Please keep these instructions for future reference as they contain important information.
WARNING: Do not aim at eyes or face. Only use projectiles supplied
with this toy. Do not fire at point blank range.
TO AVOID INJURY: Do not modify rounds, darts, or dart blaster.
Always wear appropriate eye-wear, sold separately.
x 20
REMOVE DARTS
IMMEDIATELY
TO MAINTAIN SMART STICK™
TO LOAD
2
A. Fully load clip with darts.
TECHNOLOGY!
Y8620/BBY17
Replace time-worn targets and shields with
Y8620/BBY17 SMART STICK REFILLS.
Each sold separately, subject to availability.
B. Load extra darts into storage.
x2
©2014 Mattel. All Rights Reserved. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Services
1-800-524-8697. Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline 01628 500303. Mattel Australia Pty.,
Ltd., Richmond, Victoria. 3121. Consumer Advisory Service - 1300 135 312. Mattel East Asia Ltd., Room 503-09, North Tower, World
Finance Centre, Harbour City, Tsimshatsui, HK, China. Diimport & Diedarkan Oleh: Mattel Southeast Asia Pte. Ltd. , No 19-1, Tower
3 Avenue 7, Bangsar South City, No 8, Jalan Kerinchi, 59200 Kuala Lumpur, Malaysia. Tel: 03-78803817, Fax: 03-78803867.
D. Pull rear handle back to lock clip into position.
Click!
CFD43
1100236421_DOM
14
Additional darts not included.
C. Insert the fully loaded clip from the left
side of the blaster with the arrowheads
pointing right.
TO FIRE
3
A. Slam rear handle forward to fire!
B. Pull and push rear handle back and forth for rapid fire!
TOP VIEW
a
C. Remove empty clip and reload!
Click!
b
2
Align marking ( )
to blaster as shown.
3