Fisher-Price C6325 User Manual

Please keep this
instruction sheet for
future reference, as it
contains important
information.

Requires three “AA”
batteries (included).

Adult assembly is
required for battery
replacement.

Tool required for
battery replacement:
Phillips screwdriver
(not included).

Learning
Puppy

™

www.fisher-price.com

C6325

Instructions

Battery Safety Information

Batteries may leak fluids that can cause a chemical burn
injury or ruin your toy. To avoid battery leakage:

• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).

• Insert batteries as indicated inside the
battery compartment.

• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the toy.
Dispose of batteries safely. Do not dispose of batteries
in a fire. The batteries may explode or leak.

• Never short-circuit the battery terminals.

• Use only batteries of the same or equivalent type,
as recommended.

• Do not charge non-rechargeable batteries.

• Remove rechargeable batteries from the toy
before charging.

• If removable, rechargeable batteries are used, they
are only to be charged under adult supervision.

FCC Note (United States Only)

Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment
and receiver.

• Consult the dealer or an experienced radio/TV
technician for help.

Note: Changes or modifications not expressly approved by
the manufacturer responsible for compliance could void the
user’s authority to operate the equipment.

1.5V x 3

“AA” (LR6)

Shown Actual Size

Please keep small parts such as the plastic tab out

of children’s reach. Throw the plastic tab away.

CAUTION

Note: A plastic tab was attached to the toy for in-store

demonstration purposes. While the tab may have
already been removed, check the back of the toy to be
sure. If the plastic tab is still attached, open the fasteners
on the back of the toy and pull and remove the tab.
Close the fasteners and throw the plastic tab away.

Before Use

For best results, we recommend replacing the batteries
that came with this toy with three, new “AA” (LR6)
alkaline batteries.

• Open the fasteners on the back of the toy to accesss the
battery compartment.

• Loosen the screws in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment
door. Throw the exhausted batteries away.

• Insert three, new “AA” (LR6) alkaline batteries.

Hint: We recommend using alkaline batteries for
longer battery life.

• Replace the battery compartment door and tighten the
screws with a Phillips screwdriver. Do not over-tighten.

• Close the fasteners on the toy.

• When sounds or lights from this toy become faint or stop,
it’s time for an adult to change the batteries!

Battery Replacement

Battery Compartment Door

On/Off
Switch