Fisher-Price B8925, C4639 Instruction Sheet
CONTENTS
Vehicle
Transmitter
7.2V Battery Pack
7.2V Charger
9V Battery
CHASSIS
Refer to label on transmitter and vehicle
for frequency. Do not race vehicles with
the same frequency.
Keep these instructions for future reference: they contain important information.
IMPORTANT: Please read all “Consumer Information” (last page) before operating your vehicle.
7.2V R/C
7.2V R/C
CAUTION:
Surfaces may become hot and cause burns if
electronics get wet. Do not operate vehicle through water or snow.
FORWARD REVERSE LEFT
RIGHT
VEHICLE OPERATION
NOT RECOMMENDED
FOR CHILDREN UNDER
8 YEARS OF AGE. AS WITH ALL ELECTRIC PRODUCTS,PRECAUTIONS SHOULD BE
OBSERVED DURING HANDLING AND USE TO PREVENT ELECTRIC SHOCK.
CAUTION-ELECTRIC TOY:
00007-1856
q Steering Adjuster
w Battery Door
e Battery Latch
r ON/OFF/SOUND Switch
*Switch Positions:
= OFF
= ON (no engine sounds)
= ON (engine sounds)
INPUT: 120VAC,60Hz, 12VA. OUTPUT: 8.5VDC, 420mA, 3.6W.
r
q
w
e
POWER SYSTEMS
Please follow the specific instructions on the next page for
detailed information regarding NiCd vehicle battery charging
and safety.
VEHICLE BATTERY INSTALLATION
1. Rotate battery latch to open position. Open battery door.
2. Insert battery pack into battery compartment as shown.
3. Plug wire connector securely into battery compartment as
shown.
4. Close battery door. Rotate battery latch to locked position.
5. To remove battery pack: turn latch, open battery door, unplug
wire connector and lift battery out.
*The battery door is designed to be removable. If it comes off
the hinges, simply reattach it.
9Vd.c.
TRANSMITTER BATTERY INSTALLATION
Your transmiter uses a 9v/6LR61 battery. It’s equipped with a special
automatic-on battery-saving feature. Just turn your vehicle ON.
Then push either control and you will be able to run and control
your vehicle.
1. Open battery door as shown.
2. Install one 9V battery with polarity (+/-) as shown inside battery
compartment.
3. Close battery door.
7.2V d.c.
Loading...