Page 1
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
C3969
Instructions
Pop ‘n Twirl
™
Building Table
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three "C" (LR14) alkaline batteries (not included).
Adult assembly is required.
Tool required for battery installation: Phillips screwdriver (not included).
™
Page 2
1.5V x 3
"C" (LR14)
Shown Actual Size
• Locate the battery compartment on the bottom of the toy.
• Loosen the screws in the battery compartment door with a Phillips screwdriver.
Remove the battery compartment door.
• Insert three "C" (LR14) alkaline batteries.
Hint: We recommend using alkaline batteries for longer life.
• Replace the battery compartment door and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
• When sounds, or motions from this toy become faint or stop, it’s time for an
adult to change the batteries!
Battery Installation
Battery
Compartment
Door
2
Page 3
Battery Safety Information
Batteries may leak fluids that can cause a chemical burn injury or ruin your
toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated on the battery compartment door.
• Remove batteries during long periods of non-use. Always remove exhausted
batteries from the toy. Dispose of batteries safely. Do not dispose of batteries
in a fire. The batteries may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to be charged
under adult supervision.
3
Page 4
• Position the tabletop on a hard, flat surface with the battery compartment
door facing up.
• Press firmly to "snap" the legs into the tabletop, as shown.
Hint: This may require some force.
Assembly
PRINTED IN CHINA C3969pr-0920
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
© 2004 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
4
Page 5
Spinning and Building Fun!
5
Press the button
for spinning action
and lively music.
• Locate the power/volume switch on the
underside of the tabletop.
• Slide the switch to the desired position: off ,
on with low volume or on with high volume .
• When your child is finished playing with the toy, slide the power/volume switch
to the off position.
Store all the pieces inside the table.
Power/Volume Switch
Page 6
•Wipe this toy with a clean cloth dampened with a mild soap and water solution.
• Do not immerse this toy.
Care
Questions? We'd like to hear from you!
Call Fisher-Price®Consumer Relations, toll-free at 1-800-432-5437,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers using
TTY/TDD equipment, please call 1-800-382-7470. Or, write to:
Fisher-Price®Consumer Relations, 636 Girard Avenue,
East Aurora, New York 14052.
Consumer Information
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user's authority to operate the
equipment.
FCC Note (United States Only)
6
For countries outside the United States:
CANADA: Questions? 1-800-567-7724. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.
GREAT BRITAIN: Mattel UK Ltd, V
anwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500302.
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Loading...