
BCN10
Each time power is turned ON, this toy will be in demonstration mode, with
limited function. To turn off demonstration mode:
• Shake the boat and place in water. The boat will travel a short distance.
• Remove the boat from the water.
• Shake the boat 7 or 8 times and place in the water again. The boat will
have full function and travel a longer distance.
If you turn power OFF and back ON again, repeat this process for full function.
BCN10
BCN13
• Please keep this instruction sheet for future reference, as it contains
important information.
• Requires two AAA batteries (included) for operation.
• Batteries included are for demonstration purposes only.
• Battery installation is required. Only adults should install batteries.
Tool required: Phillips screwdriver (not included).
• This toy is to be operated in water only when it is fully assembled in
accordance with the instructions.
• This toy will only travel in water.
• Each sold separately and subject to availabilty.
fisher-price.com

Battery Replacement
Note: To avoid moisture in the battery
compartment, replace the battery
compartment door after replacing
batteries. Tighten the screws in the
battery compartment door with a Phillips
screwdriver. Make sure the battery
compartment door is fully assembled,
according to these instructions, when
using this toy in water.
• For longer life, use alkaline batteries.
• Locate the battery compartment on the bottom of the toy.
• Loosen the screws in the battery compartment door with a Phillips
screwdriver. Remove the battery compartment door.
• Remove the exhausted batteries and dispose of them properly.
• Insert two, new AAA (LR03) alkaline batteries.
• Replace the battery compartment door and tighten the screws.
• If this toy begins to operate erratically, you may need to reset the electronics.
Press the power button to turn off and back on.
• When sounds become faint or stop, it’s time for an adult to change the batteries.
• Protect the environment by not disposing of this product with
household waste (2002/96/EC). Check your local authority for
recycling advice and facilities.
Battery Safety Information
In exceptional circumstances, batteries may
burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted
batteries from the product. Dispose of batteries safely. Do not dispose of this
product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged
under adult supervision.
leak fluids that can cause a chemical
1,5V x 2
AAA (LR03)

Shake it and race it!
Press to turn power
ON or OFF
• Shake the boat to start the engine.
• For maximum distance, shake vehicle 7 or 8 times. Shaking more than this
does not increase distance it will travel.
• Place in water and watch it go!
Note: Water toys sometimes get messy. Do not play with this toy on surfaces
that can be damaged by water. Protect these play surfaces.
• After each use, drain and rinse this toy. Dry thoroughly before storing.
• Wipe this toy with a clean cloth dampened with a mild soap and
water solution.
• This toy has no consumer serviceable parts. Do not take this toy apart.

FCC Statement (United States Only)
This equipment has been tested
and found to comply with the limits
for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment
generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there
is no guarantee that interference
will not occur in a particular
installation. If this equipment does
cause harmful interference to
radio or television reception, which
can be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation between
the equipment and receiver.
• Consult the dealer or an
experienced radio/TV technician
for help.
Note: Changes or modifications
not expressly approved by the
manufacturer responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may
cause undesired operation.
©2013 Mattel. All Rights Reserved.
MER ASSISTAN
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
ICES-003
This Class B digital apparatus
complies with Canadian ICES-003.
Operation is subject to the following
two conditions: (1) this device may
not cause harmful interference and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
NMB-003
Cet appareil numérique de la classe B
est conforme à la norme NMB-003 du
Canada. L’utilisation de ce dispositif est
autorisée seulement aux conditions
suivantes: (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même
si ce brouillage est susceptible de
compromettre le fonctionnement
du dispositif.
BCN10pr-0920PRINTED IN CHINA