Fisher-Price B2408 User Manual
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
B2408
Instructions
Crawl & Slide Arcade
™
™
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tool needed for assembly: Phillips Screwdriver (not included).
This product requires three “AA” batteries (included) for operation.
Arcade
2 Retainers
Slide
2 Large
Arch Pieces
Inflatable Ball
Ball Wheel Bracket
2 Small
Arch Pieces
Bracket
Ball Wheel
Base
Ramp
Open Ball Drop
Ball Drop
2 Support Tubes
#8 x 1.25" Screw - 4
Note: The #8 x 1.25" screws are
used only in assembly step 21.
#8 x .625" Screw - 25
BOTH SHOWN ACTUAL SIZE
Note: Tighten and loosen all
screws with a Phillips Screwdriver.
Do not over-tighten the screws.
Part Not Shown: 4 Balls
Parts
2
1
• Place the arcade face up on a flat surface.
• With the smooth side of the slide facing down, fit the slide onto the
four pegs on the arcade.
Arcade
Slide
2
• Plug the slide connector into the arcade connector. Push firmly to be
sure the connectors are completely joined.
Hint: Do not force the connectors together. If you cannot join them
easily, turn one of the connectors over and try again!
Connectors
3
• Lift the slide slightly.
• Fit the retainers onto the pegs of the arcade-slide assembly.
• Insert four .625" screws into the retainers and tighten.
• Set this assembly aside.
Retainer
This product contains small parts
in its unassembled state.
Adult assembly is required.
CAUTION
Slide
Retainer
Assembly
3
WARNING
To prevent injury from falls:
• Use slide position for skilled walkers only.
• Keep product away from objects child
may fall on.
• Never leave child unattended.
5
• Turn the open ball drop upside-down.
• Fit the open ball drop to the corner of the base-ramp assembly,
as shown.
Hint: You may want to prop up the end of the base-ramp assembly.
Open Ball Drop
6
• Insert two .625" screws into the open ball drop and tighten.
7
• Turn the other ball drop upside-down.
• Fit the ball drop to the corner of the base-ramp assembly, as shown.
Ball Drop
4
• Turn the ramp and base upside-down with the ribbed side up.
• Fit the base onto the pegs on the ramp.
• Insert five .625" screws into the base and tighten.
Base
Ramp
Assembly
4
Loading...