Fisher-Price B1832 Instruction Sheet
B1832
Instructions
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Ramps Around Garage
™
Please keep this instruction sheet for future reference, as it contains important information.
Requires three "AA" (LR6) alkaline batteries (not included).
Adult assembly is required.
Tool required for assembly and battery installation: Phillips screwdriver (not included).
2
Parts
CAUTION
This product contains small parts in its unassembled state.
Adult assembly is required.
Parts Not Shown:
Label Sheet
Car
Tow Tr uc k
2 Figures
#6 x 1" Screw - 4
Shown Actual Size
#6 x 1/2" Screw - 6
Shown Actual Size
Elevator Elevator Handle
Elevator Roof
Upper Track
Lower Track
Track Support
Garage Base
Diagnostic Center
Post
Gate
Ramp
Vacuum
News Stand
2 Fences
Note: Tighten and loosen all
screws with a Phillips screwdriver.
Do not over-tighten the screws.
3
Assembly
• Position the elevator on a flat surface. Note the locations
of the bottom slots and the upper tabs on the elevator.
• Hold the base at an angle. While making sure the upper
tabs on the elevator fit into the grooves in the base ,
insert the tabs on the base into the bottom slots on the
elevator .
• Press down on the base to "snap" the elevator in place.
1
2
• Fit the elevator roof on the elevator.
• Insert four #6 x 1" screws into the elevator roof and tighten.
Elevator Roof
Bottom Slots
Elevator Upper Tabs
Base Grooves
Tabs
• Place the garage on its side on a flat surface, as shown.
• Fit the connectors on the end of the ramp into the holes
on the top of the base. Be sure to fit the hooked tab on
the side of the elevator into the slot on the ramp. Press
the ramp until it "snaps" in place.
• Place the garage upright again.
Hooked Tab
Slot
• Slide and "snap" the
diagnostic center into
the base.
• Turn the base over and insert two
1
/2"
screws into the
base. Tighten the screws.
• Turn the base upright.
Diagnostic Center
3
4
Bottom View
Ramp
Loading...