Fisher-Price B0772 User Manual
D
i
s
c
o
v
e
r
w
h
a
t
’
s
p
o
s
s
i
b
l
e
™
…
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Bouncer
Classical Chorus
™
Model Number: B0772
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.Tool required for assembly:
Phillips Screwdriver (not included).
Requires three “C”(LR14) alkaline batteries (not included).
2
Warning and Caution
To prevent serious injury and/or falls:
• Never use on any elevated surface,
since child’s movement may cause
bouncer to slide or tip over.
• Never use as a carrier or lift while child
is seated.
• Always use the restraint system.
• Never leave child unattended.
• Never use as a car seat.
• Never use with a child able to sit
up unassisted.
WARNING
This package contains small parts
in its unassembled state.
Adult assembly is required.
CAUTION
Parts
3
Toybar
Pad
Seatback
Tub e
Retainer
Retainer
Soothing Unit
Right Base Wire
Left Base Wire
Footrest
Base Tube
#8 x 3/4" Screw - 2
Shown Actual Size
Battery Installation
4
1.5V x 3
“C” (LR14)
SHOWN ACTUAL SIZE
Battery Compartment Door
Battery Tips
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use. Always remove
exhausted batteries from the product. Battery leakage and corrosion
can damage the product. Dispose of the batteries safely.
• Do not dispose of batteries in a fire.The batteries may explode or leak.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recommended in the
“Battery Installation” instructions are to be used.
• If removable rechargeable batteries are used, they are only to be charged
under adult supervision.
• Rechargeable batteries are to be removed from the product before they
are charged.
• If you use a battery charger,it should be examined regularly for damage to
the cord, plug, enclosure and other parts. Do not use a damaged battery
charger until it has been properly repaired.
• Loosen the screw in the soothing unit battery compartment door with
a Phillips screwdriver. Remove the battery compartment door.
• Insert three “C” (LR14) alkaline batteries, as indicated inside the
battery compartment.
• Replace the battery compartment door and tighten the screw with a
Phillips screwdriver. Do not over-tighten.
Hint: We recommend the use of alkaline batteries for longest battery life.
• Place the base tube on a flat surface
as shown.
• Position the left and right base wires as
shown. Note the location of the colored
tabs on the left and right base wires.
• Fit the left base wire into the base tube.
• Fit the right base wire into the base tube.
• Make sure both colored tabs on the base wires are visible through the
holes in the base tube.
1
Base Tube
Colored Tab
Back View
Base Wire
Assembly
Base Tube
Left Base Wire
Colored Tabs
Right Base Wire
5
2
Soothing Unit
Clip Screw
Footrest
Soothing Unit
• Loosen the screw in the soothing unit clip with a Phillips screwdriver.
• Slide the soothing unit onto the footrest, as shown. Make sure the footrest
is completely in the grooves around the sides and back end of the
soothing unit.
• Tighten the screw in the soothing unit clip with a Phillips screwdriver.
Do not over-tighten.
Loading...