Fisher-Price 79619 User Manual
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Bouncer
Cover’n Play
™
Model Number: 79619
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.Tool required for assembly:
Phillips Screwdriver (not included).
Requires one “D”(LR20) alkaline battery (not included).
2
Warning
To prevent serious injury and/or falls:
• Never use on any elevated surface,
since child’s movement may cause
bouncer to slide or tip over.
• Never use as a carrier or lift while child
is seated.
• Always use the restraint system.
• Never leave child unattended.
• Never use as a car seat.
• Never use with a child able to sit
up unassisted.
WARNING
Parts
3
#8 x 3/4" Screw - 2
3 Toys
Toy Bar
Pad
Footrest
Seat Back
Tub e
Retainer
Retainer
Right Base Wire
Left Base Wire
Base Tube
Shown Actual Size
• Locate the soothing unit on the footrest.
• Insert a coin into the battery compartment door and pry the battery
compartment door off.
• Insert one “D” (LR20) alkaline battery, as indicated inside the battery
compartment. Be sure to place the battery on top of the ribbon.
• Replace the battery compartment door and be sure it snaps securely closed.
Battery Installation
4
1.5V
“D” (LR20)
SHOWN ACTUAL SIZE
+
–
Battery Compartment Door
+
–
Battery Tips
• Remove the battery during long periods of non-use. Always remove an
exhausted battery from the product. Battery leakage and corrosion can
damage the product. Dispose of the battery safely.
• Do not dispose of the battery in a fire. The battery may explode or leak.
• Never short circuit the battery terminals.
• A non-rechargeable battery is not to be recharged.
• Only a battery of the same or equivalent type as recommended in the
“Battery Installation” instructions is to be used.
• If a removable rechargeable battery is used, it is only to be charged under
adult supervision.
• A rechargeable battery is to be removed from the product before it
is charged.
• If you use a battery charger,it should be examined regularly for damage
to the cord, plug, enclosure and other parts. Do not use a damaged
battery charger until it has been properly repaired.
Hints:
• We recommend the use of an alkaline battery for longest battery life.
• For easy battery removal, simply lift the ribbon.
• Place the base tube on a flat surface as shown.
• Position the left and right base wires as shown. Note the location
of the colored tabs on the left and right base wires.
• Fit the left base wire into the base tube.
• Fit the right base wire into the base tube.
Assembly
Base Tube
Left Base
Wire
Colored Tabs
Right Base
Wire
1
5
This package contains small parts
in its unassembled state.
Adult assembly is required.
CAUTION
Loading...