Fisher-Price 79011 Instruction Sheet

SOOTHING SOUNDS
DELUXE BOUNCER SEAT
Model Number: 79011
Adult assembly is required.
Please save these instructions for future reference.
Tool needed for assembly: Phillips screwdriver (not included).
Requires three “C” (LR14) alkaline batteries (not included) in the soothing unit.
Occasionally a consumer may experience
a problem with one of our products.
If this should happen, please call us toll-free,
rather than return this product to the store.
Usually, we can solve the problem over the telephone
or send you replacement parts.
Please call Fisher-Price
®
Consumer Affairs,
toll-free at 1-800-432-KIDS,
between 8 AM - 5 PM EST, Monday through Friday.
Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382-7470.
Or write to:
Fisher-Price® Consumer Affairs
636 Girard Avenue
East Aurora, New York 14052
CONSUMER INFORMATION
WARNINGS
To prevent serious injury and/or falls:
• Never use on any elevated surface.
• Never use as a carrier or lift while child is seated.
• Always use the restraint system.
• Never leave child unattended.
• Never use as a car seat.
• Never use with a child able to sit up unassisted.
WARNING
PARTS
#8 - 32 x 1/2"
Screw - 2
Shown Actual Size
Toy Bar
Mirror
Pad
3 Rings
Footrest Wire
Soothing Unit
2 Paddles
Seatback
Wire
Right Base
Wire
Left Base
Wire
Base
Connector
#8 - 32 Nut - 2
Shown Actual Size
BATTERY INSTALLATION
• Locate the soothing unit on the footrest wire.
• Loosen the screw in the soothing unit battery compartment door with a Phillips screwdriver.
• Remove the battery compartment door.
• Insert three "C" (LR14) batteries, as indicated inside the battery compartment.
• Replace the battery compartment door. Tighten the screw with a Phillips screwdriver. Do not over-tighten.
Battery Compartment Door
1.5V x 3
“C” (LR14)
SHOWN ACTUAL SIZE
+
Battery Tips
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use. Always remove the exhausted batteries from the product. Battery leakage and corrosion can damage the product. Dispose of the batteries safely.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recommended in the “Battery Installation” instructions are to be used.
• If removable rechargeable batteries are used, they are only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the product before they are charged.
• If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclo­sure and other parts. Do not use a damaged battery charger until it has been properly repaired.
• Place the base connector on a flat surface as shown.
• Position the left and right base wires as shown. Note the locations of the colored dots on the left and right base wire.
• Fit the left base wire into the base connector.
• Fit the right base wire into the base connector.
Make sure both colored dots on the base wires are covered by the base connector.
1
Base
Connector
Colored Dots
Right Base
Wire
Left Base
Wire
This package contains small parts.
Adult assembly is required.
CAUTION
ASSEMBLY
Loading...
+ 11 hidden pages