Battery Installation
Reqiures four “C” (LR14) alkaline batteries for operation
(not included). Tool required for battery installation:
Phillips screwdriver (not included).
• Locate the battery compartment door on the back of the
message center.
• Loosen the screw in the battery compartment door with
a Phillips screwdriver.
• Remove the battery compartment door.
• Insert four “C” (LR14) alkaline batteries, as indicated
inside the battery compartment.
• Fit the tab on the battery compartment door into the slot in
the battery compartment. Close the battery compartment
door and tighten the screw with a Phillips screwdriver.
Do not over-tighten.
Hint: We recommend using alkaline batteries for longer
battery life.
Battery Tips
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Remove the batteries during long periods of non-use. Always remove exhausted batteries from
the toy. Battery leakage and corrosion can damage this toy. Dispose of batteries safely.
• Do not dispose of batteries in a fire. The batteries may explode or leak.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recommended in the "Battery Installation"
instructions are to be used.
• If removable rechargeable batteries are used, they are only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the toy before they are charged.
• If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclosure
and other parts. Do not use a damaged battery charger until it has been properly repaired.
1.5V x 4
“C” (LR14)
Shown Actual Size
4
Message
Center