w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Product Number: 77974
Please keep this instruction sheet for future reference, as it contains important information.
Adult assembly is required.
Tool required for battery installation: Phillips Screwdriver (not included).
This product requires three “AAA” (LR03) alkaline batteries
for operation (not included).
Fun Sounds Garage
Fun Sounds Garage
Fun Sounds Garage
™
Parts
2
2 Balconies
Long Ramp
Top Floor
Elevator Shaft
Base
Not Shown: Label Sheet
2 Little People®Figures
Car
Printed in Mexico 77974a-0920
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.
©2001 Mattel, Inc. All Rights Reserved.® and ™ designate U.S. trademarks of Mattel, Inc.
Assembly
3
• Position the elevator shaft on a flat surface.Note the
locations of the bottom slots, snap slot and retainer on
the elevator shaft.
• While holding the base at an angle, fit the locator tabs
into the bottom slots in the elevator shaft A.
• While making sure the base lip fits over the elevator
shaft ledge B, insert and snap the hooked tab on the
base into the slot in the elevator shaft C.
• Insert and snap the tab on the side of the base ramp
into the retainer in the elevator shaft D.
• Insert and snap all five top floor columns into the
grooves in the base. Make sure the top floor lip fits
over the elevator shaft ledge.
1
2
A
A
B
C
B
C
D
Elevator Shaft Ledge
Base
Lip
Base
Tabs
Retainer
Bottom Slots
Elevator Shaft
Elevator
Shaft
Ledge
Top Floor Lip
Base
Groove
Grooves
To p
Floor
Columns
Groove
D