Page 1
Product Number: 73386
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tool needed to remove beginner base: Phillips Screwdriver (not included).
Ages 5+. Weight Limit: 60 lbs. (27 kg).
Protective equipment shown in these photos is not included.
Pro
with pro base
Beginner
with beginner base
Page 2
2
WARNING
To prevent injury: Always wear protective equipment
including helmet, wrist guards, knee pads and elbow pads
(not included). Always wear shoes.
IMPORTANT! Please take a few moments to review the following safety tips
with your child.
• Your child should wear a helmet, wrist guards, knee pads and elbow pads
to guard against bumps and bruises.
• An adult should supervise beginners.
• Never use the pogo stick without the beginner bumper base or pro
bumper base.
• Never use the pogo stick on grass, soft, sandy, wet or uneven surfaces.
• Your child should wear shoes or sneakers that provide good support.
Safety
Safety TT
ips
ips
Consumer Information
Consumer Information
Questions? We’d like to hear from you!
If you’d like to order replacement parts, or if you have any questions about this product,
please call Fisher-Price
®
Consumer Relations, toll-free at 1-800-432-KIDS, 8 AM - 6 PM
EST Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382-7470. Or, write to: Fisher-Price
®
Consumer Relations, 636 Girard
Avenue, East Aurora, New York 14052.
Canada: call 1-800-567-7724, or write to: Mattel Canada Inc, 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.
Great Britain: telephone 01628 500303.
Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
Page 3
3
Let’
Let’
s Go
s Go
IMPORTANT! NEVER bounce on the
pogo stick at an angle. You will not
be able to balance properly on the
pogo stick.
• Always bounce on the pogo stick
in a vertical position.
Page 4
4
Remov
Remov
e and Stor
e and Stor
e the Beginner Base
e the Beginner Base
• Loosen all four screws in the
base retainers with a Phillips
screwdriver. The screws will
remain in the base retainers.
1
• Lift to remove the base retainers
from the beginner base.
2
Base
Retainer
Base
Retainer
Beginner
Base
When your child’s ready to bounce like a pro, remove the beginner base.
Store the beginner base in a safe place for future use.
Page 5
5
Remov
Remov
e and Stor
e and Stor
e the Beginner Base
e the Beginner Base
3
4
• While pushing down on the
beginner base, lift the stick.
• Replace the base retainers into
the beginner base.
• Tighten the screws with a Phillips
screwdriver. Do not over -tighten.
Stick
PUSH
PUSH
Base
Retainer
Base
Retainer
Page 6
Replacing P
Replacing P
arts
arts
6
• Call Fisher-Price®Consumer
Relations to obtain a new
beginner base bumper ring.
• Using a Phillips screwdriver,
loosen and remove the screws in
the beginner base bumper ring.
• Remove and discard the worn
beginner base bumper ring.
• Replace the beginner base
bumper ring with a new,
Fisher-Price®bumper ring.
• Replace the eight screws through
the bumper ring and tighten
with a Phillips screwdriver. Do
not over-tighten.
• Call Fisher-Price
®
Consumer
Relations to obtain a new
beginner base center bumper.
• Using a Phillips screwdriver,
loosen and remove the screws in
the beginner base center bumper.
• Remove and discard the worn
beginner base center bumper.
• Replace the beginner base center
bumper with a new, Fisher-Price
®
center bumper.
• Replace the four screws through
the center bumper and tighten
with a Phillips screwdriver. Do
not over-tighten.
IMPORTANT! Periodically inspect the pogo stick for wear and broken parts.
Some parts may be replaceable. Please call Fisher-Price
®
Consumer Relations at
1-800-432-KIDS for further information.Parts are available for a nominal cost.
Use the instructions on pages 6 and 7 to replace these parts.
Beginner Base
Bumper Ring
Beginner Base
Center Bumper
Page 7
7
Replacing P
Replacing P
arts
arts
• Call Fisher-Price®Consumer
Relations to obtain a new pro
base bumper.
• Simply pull to remove the pro base
bumper from the stick. Throw
away the worn pro base bumper.
• Push to fit the new, Fisher-Price
®
pro base bumper onto the bottom
of the stick.
• Call Fisher-Price
®
Consumer
Relations to obtain new
handgrips.
• Simply pull to remove the
handgrips from the handlebar.
Throw away the worn handgrips.
• Push to fit the new, Fisher-Price
®
handgrips onto the handlebar.
Pro Base
Bumper
Handgrips
Page 8
Car
Caree
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. Printed in China
©2002 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. 73386pr-0920
• Your pogo stick has been
lubricated at the factory. We do,
however, recommend that you
periodically lubricate the pogo
stick for proper function.
• Turn the pogo stick upsidedown.
Apply a few drops of oil into the
indents in the footpegs, as shown.
• Check the plastic parts regularly
and if broken or cracked, dispose
of them properly. Please call
Fisher-Price®Consumer Relations
to see if the part is replaceable.
• To clean the base, footpegs and
handlebar, use a mild soap and
water solution and clean cloth.
Rinse clean with water to remove
soap residue.
• Do not wash the stick portion of
this toy.
Oil
Oil
Indents
Loading...