LLiifft &
t &LLoocck k SSwwiinngg
Instructions
Model Numbers 75970, 75960
Please save these instructions for future reference.
No assembly is required.
For children 9 months - 3 years and up to 45 lbs.
• Falls onto hard surfaces could result
in head or other serious injuries.
• Never place over concrete, asphalt,
wood or other hard surfaces.
• Always use the restraint system.
• Never leave child unattended.
WARNING
IMPORTANT!
• Do not allow use of the Lift & Lock Swing until it
has been properly installed by an adult, according
to these instructions.
• Install the swing at least three feet from any structure
or obstruction such as a tree trunk, fence, garage,
house, overhanging branches, laundry lines or
electrical lines.
• Do not use the swing as an infant seat.
• Place only one child at a time in the swing.
• Adult supervision is essential to ensure that children
play safely.
• Make sure your child is dressed appropriately to
avoid potential hazards while using the swing. Your
child should not wear loose clothing such as ponchos
or scarves. Attire should include well-fitting shoes.
• Place child in the center of the swing. Make
sure the restraint belt and the restraint bar are
properly secured.
• Review the following safety tips with your child
before use:
– Do not walk close to, in front of, or behind the
swing while it is in use.
– Do not twist or spin the swing.
– Do not push the swing when it is not occupied.
– Do not stand in the swing.
– Do not get out of the swing while it is in motion.
2 4
Installation of the
Lift & Lock Swing
The Lift & Lock Swing can be attached to a swing set,
pole or tree branch.
IMPORTANT! When installing the Lift & Lock Swing,
be sure it cannot swing to within three feet of any
other object in front of, behind, or to the side of it.
CAUTION
Periodically inspect S-hooks for wear.
Metal to metal contact between hooks
may cause premature wear. If your swing
set does not have a bushing, you may
want to replace the existing hook with a
hook and bushing assembly available at
toy stores and home centers.
Swing Set Installation
Swing Set
Hooks
(not included)
S-Hook
(included)
Bushing
(not included)
• Fasten the Lift & Lock Swing S-hooks (included) onto
the hooks (not included) on your swing set.
Placement and
Play Area Surfacing
Before installing the Lift & Lock Swing, select and
prepare a play area.
Placement
Install the swing at least three feet from any structure or
obstruction such as a tree trunk, fence, garage, house,
overhanging branches, laundry lines or electrical lines.
Surfacing
Following are guidelines from the Consumer
Product Safety Commission’s Handbook for Public
Playground Safety to minimize injuries that can result
from falls. These guildelines apply to playground
equipment including but not limited to swing sets and
climbing equipment.
Hard surfacing materials are not suitable for use
under this equipment. Earth surfaces such as soils
and hard packed dirt are also not recommended
because their shock absorbing properties can vary
depending on climatic conditions such as moisture and
temperature. Grass and turf are not recommended
because their effectiveness in absorbing shock during
a fall can be reduced considerably due to wear and
environmental conditions.
Acceptable surfacing materials are available in two
basic types: loose-fill and unitary.
Loose-fill materials can have acceptable shock
absorbing properties when installed at sufficient
uncompressed depth of at least 6 inches. These
materials include sand (fine and coarse), gravel (fine
and medium) and shredded wood products (wood
mulch, shredded bark, wood chips). Loose-fills should
not be installed over hard surfaces such as asphalt
or concrete.
The depth of any loose-fill material could be reduced
during use resulting in different shock-absorbing
characteristics. For this reason, a depth greater than
the minimum recommended should be considered.
Unitary materials are generally rubber mats or a
combination of rubber-like materials held in place
by a binder that may be poured in place at the
playground site and cures to form a unitary shock
absorbing surface.
3
75970b-0920.qrk 10/6/0 11:45 AM Page 1