Fisher Price 71597T, 71597R User Manual
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Model Number: 71597
For proper set-up and use,read these instructions.
Please keep this instruction sheet for future reference,
as it contains important information.
Transmitter is electically powered.
Remote control/receiver is powered by the AC adaptor
(included - standard household outlets 120V AC) or battery
(9V alkaline batttery - not included).
An adult must install the battery (if used).
Soothing Dreams
Monitor
with Remote Control
TM
This product cannot replace
responsible adult supervision.
CAUTION
IMPORTANT!
2
• This product is not intended to be used as a medical monitor
and its use should not replace adult supervision.
• Test sound remote control/receiver before first-time use and
whenever you change location of transmitter.
• To prevent entanglement:
- Never place transmitter in a crib or playpen. Keep transmitter
and receiver out of baby’s reach.
- Never use extension cords with the AC adaptor.
• Never use transmitter or remote control/receiver near water
(ie.: bathtub, sink,laundry tub or wet basement, etc.).
• Always use transmitter and remote control/receiver where there is
adequate ventilation.To prevent overheating, keep transmitter and
remote control/receiver away from heat sources such as radiators,
heat registers, direct sunlight, stoves, amplifiers, or other appliances
which produce heat.
Occasionally a consumer may experience a problem with one of our
products. If this should happen, please call us toll-free, rather than
return this product to the store. Usually, we can solve the problem
over the telephone or send you replacement parts.
Please call Fisher-Price® Consumer Relations, toll-free at
1-800-432-KIDS, between 8 AM - 6 PM EST, Monday through Friday.
Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382-7470.
Or write to:
Fisher-Price® Consumer Relations
636 Girard Avenue
East Aurora, New York 14052
Consumer Information
Remote Control/Receiver
Battery Installation (optional)
3
Battery
Compartment Door
• Locate battery compartment door on the back of remote
control/receiver.
• Loosen the screw in the battery compartment door with a Phillips
screwdriver. Lift to remove the battery compartment door.
• Snap the terminals of a fresh, 9V alkaline battery into the
remote control/receiver connectors.
• Replace the battery compartment door and tighten the screw.
Do not over-tighten.
Battery Tips
• Remove the battery during long periods of non-use. Always
remove an exhausted battery from the product. Battery leakage
and corrosion can damage this product. Dispose of battery safely.
• Do not dispose of batteries in a fire.The batteries may explode
or leak.
• Never short circuit the battery terminals.
• A non-rechargeable battery is not to be recharged.
• Only a battery of the same or equivalent type as recommended in
the “Battery Installation”instructions is to be used.
• If a removable rechargeable battery is used, it is only to be charged
under adult supervision.
• A rechargeable battery is to be removed from the product before
it is charged.
• If you use a battery charger,it should be examined regularly for
damage to the cord, plug, enclosure and other parts. Do not use
a damaged battery charger until it has been properly repaired.
9V (6LR61)
SHOWN ACTUAL SIZE
Testing Sound Reception
4
Test transmitter transmission and
remote control/receiver reception.
Place transmitter in room in which
you intend to use it. Slide transmitter
power switch to turn power on.Turn
on a radio.
Place remote control/receiver in
room in which you intend to use it.
Rotate power/volume dial to turn
power on. Adjust remote control/
receiver location.
If you experience interference (buzzing
or static, etc.) while using one channel
setting, switch both units to other
channel. Selecting a channel is usually
a one time adjustment.
Notes:
• Variable light display lights when
sound is received by remote
control/receiver.
• If all four dots in variable light
display light:
- Remote control/receiver power is
on and transmitter power is off.
- Remote control/receiver is too far
away from transmitter.
- Remote control/receiver and trans-
mitter are not on same channel.
- Loud sounds are transmitting.
Hint: If you turn remote control/receiver power on before transmitter power, you will
hear a static noise and all four dots in variable light display light. Simply turn volume
down and turn transmitter power on.
Setup and Use
5
1
1
2
3
4
IMPORTANT! Test sound reception of this monitor before first time
use and whenever you change location of transmitter (see page 4).
Set transmitter channel switch to same channel as receiver.
Choose a soothing mode:
Lights
Music
Light and Nighttime Nature Sounds/Music
Choose a light mode (only if you have selected Lights
or Light and Nighttime Nature Sounds/Music in
soothing mode)
Ceiling Light Show
Night Light
Press the soothing button to activate your selection. Light(s);
Music; Light and Nighttime Nature Sounds/Music will turn on
for about five minutes and then automatically turn off.
1
2
3
4
Setup and Use
Hint: If you do not want light(s) and music/sound effects on, do not press
the soothing button on the transmitter.
6
SFX
SFX
SFX
Loading...