Fisher-Price 71590 Instruction Sheet

SOUND‘N LIGHTS

NURSERY MONITOR

WITH DUAL RECEIVERS

Product Number: 71590

•Adult assembly is required to install this battery (if used – not included).

•For proper setup and use, please read these instructions and keep for
future reference.

•Includes three AC adaptors to power transmitter and receivers (plugs into
standard household outlets –120V AC). Receivers also run on battery
power (9V alkaline battery for each receiver – not included).

O

F

F

ON

P

O

W

E

R

C

H

A

N

N

E

L

A

B

PROBLEMS AND SOLUTIONS

PROBLEMS SOLUTIONS

1

Transmitter power off. Power indicator not lit.

2

You hear static or buzzing because transmitter channel switch is not on
same channel as receiver(s).

3

Transmitter power off. Power indicator not lit. Light switch that controls
power flow to wall outlet off.

4

Transmitter power off. Power indicator not lit. AC adaptor cord
plug-to-outlet not connected.

5

Transmitter power off. Power indicator not lit. Power is off because
circuit breaker for baby’s room off.

6

You hear static or buzzing and all
five bars lit on receiver.

1

Turn transmitter power on. Power indicator lights.

2

Make sure channel switches on both transmitter and receiver(s) set to same channel.

3

Make sure light switch that controls power flow to wall outlet is on.

4

Check AC adaptor cord plug-to-outlet connection.

5

Make sure house fuses and circuit breakers are on.

6

Check all five solutions above. Any one or more of these solutions should solve
the problem.

Helpful Hint: If, after checking all of these solutions, you believe that your
AC adaptors are damaged, please call Fisher-Price®at 1-800-432-KIDS.

PROBLEM

You can hear conversations or
sounds from other homes. There
is signal interference due to other
nursery monitor systems on same
channel or cordless telephones.

SOLUTION

Change channel switches on both transmitter
and receiver(s) to eliminate source
of interference.

Helpful Hints:

- Do not use more than one nursery monitor
system at same time in same household.

- Always remember that you are using
public airwaves when using your nursery
monitor system. Conversations, even from
rooms near transmitter, may broadcast to
other nursery monitors, radios, cordless
telephones, or scanners outside your
home. To protect privacy of your home,
always turn transmitter off when not
in use.

PROBLEM SOLUTION

Circuit Breaker

OFF

ON

POWER

CHANNEL

AB

3

1

2

4

2

6

BUZZZZ

BUZZZZZ

BUZZZZZ

5

STATIC

STATIC

STATIC

2

“Ma, ma, ma.
Da, da, da…”

“Did you read

about…”

“Did you read

about…”

“Wah, Wah,

Wah…”

“Wah, Wah,

Wah…”

“Wah, Wah,

Wah…”

1

You hear static or buzzing because receiver is out
of range of transmitter.

Note: Range varies depending on surrounding
conditions such as noise levels, physical obstructions
and signal interference.

Move receiver closer to transmitter.

Helpful Hint:

- If you cannot hear your child and all five bars do not light, your
receiver battery is weak. Replace receiver battery with a fresh,
9V alkaline battery or use AC adaptor for power source.

IMPORTANT!

• This product is not intended to be used as a medical monitor
and its use should not replace adult supervision.

• Test sound reception of each receiver before first-time use and
whenever you change location of transmitter.

• To prevent entanglement:

- Never place transmitter in a crib or playpen. Keep transmitter

and receiver(s) out of baby’s reach.

- Never use extension cords with the AC adaptors.

• Never use transmitter or receiver(s) near water (ie.: bathtub, sink,
laundry tub or wet basement, etc.).

• Always use transmitter and receiver(s) where there is adequate
ventilation. To prevent overheating, keep transmitter and receiver(s)
away from heat sources such as radiators, heat registers, direct
sunlight, stoves, amplifiers, or other appliances which produce heat.

CAUTION

This product cannot replace

responsible adult supervision.

Place transmitter in room in
which you intend to use it. Slide
transmitter power switch to turn
power on. Turn on a radio.

Test transmitter transmission and each receiver’s reception.

Place each receiver in the rooms in which
you intend to use them. Rotate on/off/
volume dial to turn power on. Adjust
receiver’s location for best reception.

Hint: If you turn receiver power on before
transmitter power, you will hear a static
noise and all five bars in variable light
display light. Simply turn receiver volume
down and turn transmitter power on.

O

F

F

ON

POWER

CHANNEL

A

B

If you experience interfer­ence (buzzing or static,
etc.) while using one
channel setting, switch

transmitter and receiver(s)

to other channel. Selecting
a channel is usually a one
time adjustment.

9V (6LR61)

SHOWN ACTUAL SIZE

• Locate battery compartment door on bottom of receiver.

• Push finger tab on battery compartment door to open battery
compartment door.

• Snap terminals of a fresh, 9V alkaline battery into receiver connectors.

• Close battery compartment door.

• Remove the battery during long periods of non-use. Always remove
an exhausted battery from the product. Battery leakage and corrosion
can damage this product. Dispose of battery safely.

• Never short circuit the battery terminals.

• A non-rechargeable battery is not to be recharged.

• Only a battery of the same or equivalent type as recommended in
the “Battery Installation” instructions is to be used.

• If a removable rechargeable battery is used, it is only to be charged under
adult supervision.

• A rechargeable battery is to be removed from the product before
it is charged.

• If you use a battery charger, it should be examined regularly for
damage to the cord, plug, enclosure and other parts. Do not use
a damaged battery charger until it has been properly repaired.

IMPORTANT! Test sound reception of this
nursery monitor system before first time use
and whenever you change location of
transmitter (see this page).

1

Set transmitter channel switch to same
channel as receiver.

2

Place transmitter in same room with child.
Point microphone directly toward crib or
play area.

3

Plug AC power cord into wall outlet. Unwrap
and fully extend AC adaptor cord for best
transmission. Insert AC adaptor jack into
transmitter socket and plug into wall outlet.

4

Slide transmitter on/off switch to turn power
on. Power indicator lights.

5

Place receiver where you will see or hear it.

6

Unwrap and fully extend AC adaptor cord for best reception. Insert
AC adaptor jack into receiver socket and plug into wall outlet.

Note: To use a 9V alkaline battery for power source, refer to “Receiver
Battery Installation” instructions on this page.

7

Rotate receiver on/off/volume dial to turn power on. Power
indicator lights. Rotate on/off/volume dial to adjust volume.

Battery Compartment Door

2

3

“Peek-a-boo…”

OFF

O

N

PO

W

ER

C

H

A

N

N

EL

A

B

4

1

Occasionally a consumer may experience a problem with one of our
products. If this should happen, please call us, toll-free, rather than
return this product to the store. Usually we can solve the problem on
the telephone or by sending you replacement parts. Please call
Fisher-Price®Consumer Relations, toll-free at 1-800-432-KIDS,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers
using TTY/TDD equipment, please call 1-800-382-7470. Or, write to:
Fisher-Price®Consumer Relations, 636 Girard Avenue, East Aurora,
New York 14052.

Excess dirt in transmitter microphone will hamper transmission
of sound. Clean outer surface of transmitter and receivers with
a cloth lightly dampened with a mild cleaning solution.

Never immerse transmitter, receivers or AC adaptors.

Sound ‘n Lights Nursery Monitor with Dual Receivers
Model Number: 71590
This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not
cause harmful interference and (2) this device must accept any
interference received, including interference that may cause
undesired operation.

Sound ‘n Lights Nursery Monitor with Dual Receivers
Consumer Relations Department
636 Girard Avenue
East Aurora, New York 14052

Any modification of the transmitter or receiver will violate
FCC compliance and can void the user’s authority to operate
the equipment.

Fisher-Price, Inc., 636 Girard Avenue, East Aurora, New York
14052 warrants that the

Sound ‘n Lights Nursery Monitor

with
Dual Receivers is free from all defects in material and workmanship
when used under normal conditions for a period of one (1) year
from the date of purchase.

Should the product fail to perform properly, we will repair or
replace it at our option, free of charge. Purchaser is responsible for
shipping the product to Consumer Relations at the address indicat­ed above and for all associated freight and insurance cost. Fisher­Price, Inc., will bear the cost of shipping the repaired or replaced
item to you. This warranty is void if the owner repairs or modifies
the product. This warranty excludes any liability other than that
expressly stated above including but not limited to any incidental
or consequential damages.

SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION
OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE
LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU
MAY ALSO HAVE OTHER RIGHTS WHICH MAY VARY FROM STATE
TO STATE.

The electronic components in transmitter, receivers and AC
adaptors are not designed for consumer repair. Evidence of
any attempt of consumer repair will void this warranty.

If you have any questions about this product:

In Canada, call 1-800-567-7724, or write to: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2.

In Gr

eat Britain, telephone [phone].

In Australia, Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria

3121 Australia. Consumer Advisory Service 1-800-800-812 (valid only in Australia).

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A.

©2000 Mattel, Inc. All Rights Reserved.

® and ™ designate U.S. trademarks of Mattel, Inc.

Printed in Hong Kong 71590pr-0920

5

6

“Peek-a-boo…”

TESTING SOUND

RECEPTION

BATTERY TIPS

FCC NOTE

(UNITED STATES ONLY)

ONE (1) YEAR

LIMITED WARRANTY

SETUP AND USE CARE

CONSUMER

INFORMATION

Notes:

• Variable light display lights when sound is received by receiver.

• If all five bars in variable light display light:

- Receiver power is on and transmitter power is off.

- Receiver is too far away from transmitter.

- Receiver and transmitter are not on same channel.

- Loud sounds are transmitting.

OFF

O

N

P

O

W

E

R

C

H

A

N

N

E

L

A

B

RECEIVER BATTERY

INSTALLATION

(OPTIONAL)

3

Finger Tab

OFF

ON

POWER

CHANNEL

AB

7

1

“

Peek-a-boo…”

5

ON

OFF

POWER

AB

CHANNEL

ON

OFF

POWER

AB

CHANNEL

ON

OFF

POWER

AB

CHANNEL

ON

OFF

POWER

AB

CHANNEL