Fisher-Price 50697 Instruction Sheet

INSTRUCTIONS

Requires4"e"sizealkaline
batteries(notincluded).

For ages 8

~

and over

~

(3) FigureAdapters

~

WandRetainer

CONTENTS:

Base

~

ChipboardAdapters

Chipboard Characters

Backdrop

~Q

Artifact CastingStonesTM

Wand WandCover

Pleaseremoveeverythingfromthepackageandcomparetothecontentsshownhere. ~

If anyitemsaremissing,pleasecall1-800-524-TOYS. -

Keeptheseinstructionsfor futurereferenceastheycontainimportantinformation. 50697-0920G1

QQQ

ElementCastingStonesTM

II

INSTALLI R€PIJ\C€BATT€RI€S

Remove battery cover with a Phillips
screwdriver (notincluded) and set

aside. Insert 4 "C"size alkaline
batteries (not included)as shown and

replace battery cover.

Ii:!

0

A ~

ill CAUTION: Changes or modifications not expressively approved by the manufacturer

responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.

Mattei Inc.
333 Continental Blvd.

EI Segundo, CA
[phone]

l\SS€MBLY

Follow this sequence:

1. Attach wand with two
screws provided.

2. Push wand retainer
onto four posts.

3. Attach wand cover with
four screws provided.

3.

..

i

4. Bend backdrop along
scored lines and push

into slot on base.