Fisher-Price 37553, 37554 Instruction Sheet

TOP VIEW
TRANSMITTER
Left Stick Controls Forward and Reverse
Your transmitter is equipped with a special automatic ON battery­saving feature. Just turn your vehicle ON. Then push either transmitter stick and you will be able to run and control your vehicle.
Automatic ON Power Indicator Light
Whip Antenna
FEATURES CONTENTS
(1) TMH™Pow er WAVERIPPER™Vehicle
(1) Stand
TOP VIEW
SIDE VIEW
SIDE VIEW
TRANSMITTER
Refer to label on transmitter and vehicle for frequency.
Don’t race vehicles with the same frequency.
FEATURES
Full Function
2 frequencies Available (27 MHz and 49 MHz)
Range up to 65'/20m
“SMART CIRCUITRY”
CONTENTS
37552-0920 MODEL NO. 37553 (27 MHz) MODEL NO. 37554 (49 MHz)
“SMART CIRCUITRY”
Your new vehicle is equipped with advanced “Smart Circuitry” designed to protect its electronic components under extreme operating conditions. If your vehicle stops running during use, simply allow the joysticks to return to their neutral positions momentarily, then resume normal operation.
Propeller
Battery Vehicle Latches (3)
Steering Rudder
Please see Step 2 for location of ON/OFF Switch and Battery Compartment
(1) Transmitter
Powerful Mabuchi
Motor
Right Stick Controls Turning
Keep these instructions for future reference: they contain important information.
BATTERY CHARGING/CARE
BATTERY CHARGING/CARE
(Batteries and Charger not included)
Your vehicle will not operate without the TYCO®R/C TMH™ FlexPak™ Battery Pack and Charger. The TMH™FlexPak™battery pack is designed for use exclusively in TYCO®R/C TMH™ Power vehicles. It will not work in any 6.0V or 9.6V NiCd battery-powered vehicles.
Your TMH FlexPak battery pack features a unique design (Patent Pending) which allows it to be config­ured in different ways for use in different Tyco®R/C TMH power vehicles. This feature allows maximum performance for each vehicle. To configure your FlexPak battery pack for use in this vehicle, please refer to Step 2, Battery Installation.
1. Plug the battery charger into standard wall outlet.
2. Hold the battery pack fully open, with the metal contacts at the top, as shown.
The labels marked 1 and 2 in the upper left-hand corner should be facing you. Now slide the battery pack securely into the charger.
3. To disconnect, push the red button on the side of the charger. Hold the red button down while you
slide out the battery pack.
4. New battery packs must be charged for 5 1/2 hours the first two times charged. After that,
subsequent charges will require only 4 hours.
5. After charging, the battery pack will feel warm. This is normal for fully charged batteries.
6. Unlike alkaline batteries, which lose power gradually, your TMH FlexPak battery will run for its
normal running time, depending on your particular vehicle, and then lose most of its power at once. It is now time to recharge the battery pack.
7. Unlike NiCd (Nickel-Cadmium) rechargeable batteries, your TMH FlexPak battery pack may be
recharged at any time, irrespective of the level of charge remaining in the battery: you do not have to wait until the battery pack is fully discharged to recharge it.
8. After use, the battery pack will be hot! Wait at least 20 minutes until the battery pack cools down before
recharging. Recharging a hot battery will greatly reduce the number of times your battery pack can be recharged.
BATTERY PACK CARE
Because of its unique design, other battery chargers will be unable to charge your TMH FlexPak battery pack. To charge your battery pack, use only the Tyco
®
R/C TMH FlexPak battery charger.
CAUTIONS
• DO NOT RECHARGE BATTERY PACK IF IT’S HOT. ALLOW IT TO COOL BEFORE RECHARGING.
• DO NOT RECHARGE A BATTERY PACK THAT SHOWS LEAKAGE OR CORROSION.
• DO NOT DISASSEMBLE THE BATTERY PACK. THE BATTERY PACK IS A SEALED RECHARGEABLE NICKEL­METAL HYDRIDE (NiMH) BATTERY.
• DO NOT DISPOSE OF THE BATTERY PACK IN FIRE.
• EXERCISE CAUTION IN HANDLING A HOT BATTERY PACK.
• IF BATTERY PACK AND/OR CHARGER ARE WET, THOROUGHLY DRY BEFORE CHARGING.
• DO NOT RECHARGE NON-RECHARGEABLE BATTERIES.
TMH™ FlexPak™ Battery Pack and Charger
FPO
Additional TMH™ FlexPak™ Battery Pack
Have additional Battery Packs charged ahead of time for longer non-stop racing action. Uses the TMH FlexPak Charger.
Unlike NiCd (Nickel-Cadmium) rechargeable batteries, your TMH FlexPak battery pack requires no special procedures or precau­tions for disposal. However, as with all prod­ucts, you should dispose of your battery pack in an envi­ronmentally responsible and considerate manner.
SPECIAL NOTE TO ADULTS:
• Remove rechargeable batteries before recharging. Recharge batteries only under adult supervision.
• Regularly examine for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with the transformer until the damage has been repaired.
• This toy is not intended for children under 3 years old. The transformer is not a toy.
IMPORTANT BATTERY INFORMATION:
• Insure that battery polarity is correct.
• Use only batteries of the type recommended (or equivalent).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Remove used-up batteries immediately. Remove batteries if vehicle will not be used for a long period.
• For best performance use alkaline batteries. Battery life may vary depending on battery brand. Toy performance may decrease as batteries weaken.
• Do not recharge non-rechargeable batteries.
• Do not short-circuit terminals.
• Remove rechargeable batteries before recharging. Recharge batteries only under adult supervision.
• Dispose of batteries safely.
FPO
1
2
ALSO AVAILABLE
FPO
1
2
Loading...
+ 2 hidden pages