Fisher-Price 32854 Instruction Sheet

32854-0920G1
OWNER’S MANUAL
Please read thoroughly before operating your vehicle. Keep these instructions for future reference: they contain important information.
I. CONTENTS
6.0V JET TURBO
®
HARLEY-DAVIDSON®Vehicle
Transmitter
Display Stand (store vehicle on stand
when not in use)
FEATURES
Full-function Transmitter
27 MHz or 49MHz
Range up to 65/20m
VEHICLE
Powerful Mabuchi MotorON/OFF SwitchBattery CompartmentBattery Release ButtonFunctional Suspension (front)
Functional Suspension (rear)Breakaway Rider FigureSide Stabilizers (one each side)
TRANSMITTER
Left stick
(controls forward, turbo mode and braking)
Right stick
(controls steering)
AntennaPower-On Indicator Light
®
®
®
CAUTION:
Surfaces may become hot and cause burns if electronics get wet. Do not operate vehicle through water or snow.
2
II. QUICK START
Please read this Owner’s
Manual thoroughly.
1. Start with a full charge.
2. Turn vehicle switch ON. Activate transmitter to run and control your vehicle.
3. When youre done driving, turn vehi­cle switch OFF. Remove all batteries for storage.
FORWARDFORWARD TURBOBRAKINGWIDE LEFT TURN
SHARP LEFT TURNWIDE RIGHT TURNSHARP RIGHT TURN
IV. SPECIAL DRIVING
CONTROLS & FEATURES
STANDING START
Set your vehicle on the ground, leaning on one of its side stabilizers. Push the left stick forward to drive straight ahead.
LAUNCH-START
Hold your vehicle steady on the ground (keeping your fingers clear of the wheel hubs). Gently guide your vehicle forward while pushing the left stick forward.
“SCREECHING” STOP
While driving forward, quickly jam the left stick back. Your vehicle will brake to a quick stop with one of its side sta­bilizers on the ground.
GLIDE-STOP
While driving forward, release the sticks. Your vehicle will glide to a stop with one of its side stabilizers on the ground.
TURNING CIRCLE
Your vehicle’s normal turning circle is about 30/9m. For tighter circles, try
steering in the direction of the turn while pulsing the left stick forward. (This may take a little practice!)
BREAKAWAY RIDER FIGURE
Dont operate your vehicle without the breakaway rider figure attached: the vehicle wont balance properly without it. The figure is designed to break away on impact. To reattach the figure, snap the figure into the seat, then rotate into upright position as shown.
III. OPERATING YOUR VEHICLE
Loading...
+ 4 hidden pages