BATTERY SAFETY INFORMATION:
1.
Non-rechargeable batteries are not to be recharged.
2.
Rechargeable batteries are to be removed from the product
before they are charged.
3.
If removable rechargeable batteries are used, they are only to
be charged under adult supervision.
4.
Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.
5.
Do not mix old batteries and new batteries.
6.
Only batteries of the same or equivalent type as
recommended are to be used.
7.
Be sure to insert batteries with the correct polarities and
always follow the toy and battery manufacturers' instructions.
8.
Exhausted batteries are to be removed from the product.
9.
The supply terminals are not to be short-circuited.
10.
Dispose of batteries safely.
25771-0920 G2
INSTRUCTIONS
ADULT ASSEMBLY REQUIRED.
Phillips head screwdriver
Requires 4 ÒDÓ size alkaline batteries
CONTENTS:
(not included
¨
ª
) is required for assembly.
(not included).
ABCD
Keep these
instructions
for future
reference, as
they contain
important
information.
CONSUMER INFORMATION
YOU CAN TELL IT'S MATTEL!™ CALL us toll-free
or write with any comments or questions about
our products or service. Monday-Friday, 8:00
a.m.-6:00 p.m. Eastern Time. Outside U.S.A., see
telephone directory for Mattel listing. Consumer
Relations, Mattel, Inc., 333 Continental Blvd.,
MATTY MATTEL™ toys
El Segundo, CA 90245 USA
1 (800) 524-TOYS
CONFORMS TO THE SAFETY
REQUIREMENTS OF ASTM F963.
We are dedicated to quality products.
TWO-YEAR LIMITED WARRANTY
Mattel, Inc. warrants to the original consumer purchaser that this
product will be free of defects in material or workmanship for two
years (unless specified in alternate warranties) from the date of
purchase. If defective, return the product along with proof of the
date of purchase, postage prepaid, to Consumer Adjustment
Center, 15930 E. Valley Boulevard, City of Industry, California
91744 for replacement or refund at our option. This warranty
does not cover damage resulting from unauthorized
modification, accident, misuse or abuse. VALID ONLY IN U.S.A.
This warranty gives you specific legal rights and you may also
have other rights which vary from state to state.
F
TOWER
BACK
TOP
TOWER
CURVE
HALVES
CRASH ZONE SHIELDS
TOWER
BACK
BOTTOM
TOWER
FRONT
TOP
E
TOWER FRONT
MIDDLE UPPER
6 3 5 2 4 1
TOWER
SIDES
TOP
45¼ CURVES
TOWER SIDES
TOWER FRONT
MIDDLE LOWER
MIDDLE
RETURN CURVE
POWER-LINE
TRACK
TRESTLES
TOWER
FRONT
BOTTOM
TOWER SIDES
BOTTOM
TRANSITION
CURVES
TOWER
ACCESSORIES
Send only the product to the address above. Send all
correspondence to Consumer Relations, Mattel, Inc., 333
Continental Blvd., El Segundo, CA 90245-5012, U.S.A. Or you
may phone us toll-free at 1-800-524-TOYS, Monday through
Friday, 8:00 a.m.Ð 6:00 p.m. Eastern Time.
POWER
CHARGER
BOOSTER
© 2000 Mattel, Inc., El Segundo, CA 90245, U.S.A. All Rights Reserved.
¨
TOWER
BASE
TWISTER FACE
ACCESSORIES
LABEL SHEET
2 HOT WHEELS
CARS
5
6
¨
201/2" &151/2"
TRACKS
36 PHILLIPS
HEAD SCREWS
1
4
2
7
3
8
1
INSTALL BATTERIES
TO REMOVE
BATTERIES
Open battery cover.
Insert 4 "D" cell alkaline
batteries (not included) as
shown. Close battery cover.
Turn power switch ON to play.
ON
OFF
2
10
4
2
3
Attach Labels
and Accessories
to tower.
5
6
7
8
Label sheet
TROUBLE-SHOOTING TIPS
The playing surface is level and flat.
All
5
1 4&
TRACK
If set appears to run slowly, replace batteries with 4 fresh "D" size
alkaline batteries.
If foam wheels of
power is still on, they will turn slowly after released. Turn
for approximately 15 seconds, then turn back on.
There is some skill required in making the two cars work on the track
set at the same time. Meet the challenge and experiment with inserting
the cars into the
6
3
If you have any questions assembling toys, contact a Consumer
Relations representative at 1-800-524-TOYS. Have this instruction
sheet available and ready to reference when you make your call.
Make sure
To stabilize set: On carpet, use books; on smooth floor, tape base and
trestles to surface.
and
CURVE
BOOSTER
BOOSTER
connections are joined together tightly.
are restricted from turning while the
at different times.
CRASH ZONE SHIELDS
To ensure car travels smoothly
through track sections, adjust
tabs as shown. This prevents
car from hitting track edges.
BOOSTER
are assembled correctly.
TABS ON OUTSIDE
off
TABS ON INSIDE
8
CAR
DIRECTION
7
TO STABILIZE SET: On carpet, use books; on smooth floor, tape base and trestles to surface.
TABS ON INSIDE
CAR
DIRECTION
CAR
DIRECTION