Fisher & Paykel Traditional Microwave trim kit Installation Instructions Manual

FISHER & PAYKEL TRADITIONAL MICROWAVE TRIM KIT

INSTALLATION INSTRUCTIONS

Before you begin, read these instructions completely and carefully.

Getting Started

■ Remove packaging

Contents Tools Required

Part Description Qty

Trim Assembly 1

Base 1

Mounting Bracket (L/R) 2

Sheet Metal Screws 10

1/8” Drill

#2 Phillip Screwdriver

Installing Trim Kit

1. Cut opening in the cabinet face per the following dimensions:

Height: 17” + 1/16”, –0
Width: 24-3/4” + 1/16”, –0

Note: Refer to diagram on the following page. The minimum

cabinet depth is 20”. When installing the Microwave and
Trim Kit in combination with a Wall Oven or Warming
Drawer, please follow the recommendations in the
Microwave Installation/ Use & Care Manual.

2. Add adequate platform base support in the bottom of the
cabinet for tr

3. Mark a centerline on the front edge of the cabinet bottom
(Fig. 01).

im kit base to rest on.

Fig. 01

4. Place trim kit base and align centerline mark to the triangular
notch on the front edge of the base (Fig. 02).

5. Drill 1/8” pilot holes in the cabinet using the base as a
template and install a screw through the base into the cabinet
bottom to prevent the base from shifting (Fig. 03).

6. Insert Microwave into opening on top of the base. The
Microwave feet should sit in the recesses on the base for
correct alignment. The Microwave should be plugged in at
this point.

Fig. 02

Fig. 03

1/16"

7. Place the right and left mounting bracket supports by resting the bottom edges of the supports on the
bottom of the cutout (Fig 04). The long flange on the side supports should clear the side of the cutout by
approximately 1/16”(Fig. 05). Install top and bottom screws into the cabinet face by first drilling 1/8”
pilot holes (see inserts 3 and 4).

8. Install trim kit face by inserting top pins of trim into corresponding sockets on the top corners of clip
support plates (see insert 1).

9. Finish the assembly by inserting the bottom pins into the
corresponding sockets on front edge of the base (see insert 3). Check for proper door opening
clearances.

Bracket
Support
on the
bottom
of cutout

Fig. 05

Fig. 04