Fisher Instruction Manual: Fisher easy-Drive 200L Quick Start Guide, Quick Start Guide: Fisher easy-Drive 200L Manuals & Guides

Quick Start Guide

D104725X012

easy-Drive 200L

March 2022

Fisher™ easy-Drive™ 200L Quick Start Guide

Mounting and travel configuration for your Fisher easy-Drive 200L actuator.

Before You Begin

Do not install, operate, or maintain a 200L actuator without being fully trained and qualified in valve,
actuator, and accessory installation, operation, and maintenance. To avoid personal injury or property

damage, it is important to carefully read, understand, and follow all the contents of this quick start
guide, including all safety cautions and warnings. Refer to the Fisher easy-Drive 200L Instruction Manual

(D104331X012
installation in hazardous locations. If you have any questions about these instructions, contact your

Emerson sales office

WARNING

To avoid personal injury or property damage, keep hands and tools out of the actuator stem travel path. The actuator stem
will move during calibration and positioning steps.

Always wear protective gloves, clothing, and eyewear when performing any installation operations to avoid personal
injury.

) for product specifications, custom setup information, maintenance procedures, and

before proceeding.

Note

Refer to easy-Drive 200L Instruction Manual (D104331X012
easy-Drive actuator as this will be needed to configure and calibrate the 200L.

) for wiring, Modbus setup and connecting the Configurator to an

www.Fisher.com

easy-Drive 200L

March 2022

Quick Start Guide

D104725X012

Ensure Actuator Stem is in the Proper Position Prior
to Mounting and Coupling

Your 200L actuator has internal hard stops to limit maximum travel within the actuator. A new actuator will be shipped
from the factory at 6% off the lower internal hard stop, which is the recommended mounting position.

Note

If you are mounting a new actuator that has never been positioned and is still in its recommended mounting position of 6% of
maximum travel, you can begin at step 5.

To set the stand-alone 200L actuator to the recommended mounting position of 6% of maximum travel, follow steps
1-4:

Step 1. Ensure use of a stand-alone 200L

(must be actuator only, no valve body).

X1520-1

Step 3. Perform Span Calibration from

Calibration tab.

Step 2. Using the Fisher easy-Drive Configurator,

select the “System” tab and then
“Advanced Settings.” Select the valve
type “Stop-to-Stop” from the drop-down
options and click “Apply.”

Step 4. Position actuator to 6% travel.

Note

Stop-to-Stop is used for positioning the actuator to 6% off the lower travel stop.
Select proper valve type and travel after mounting the 200L to the valve body.

2