(1) This device may not cause harmful interference.
(2) This device may accept any interference received, including interference that may cau
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this device.
2 Way Remote Button Functions .......................................................................................................... 4
Remote Option Menu Table.................................................................................................................. 5
Remote LED Functions ........................................................................................................................ 6
1 Way Remote Button Functions .......................................................................................................... 6
General Features .................................................................................................................................... 7
Thank you for purchasing a Firstech system for your vehicle. Please take a minute to review this entire
manual. Note that this manual applies to the 2 Way 4 Button G15 LED FMX Remotes whether you
purchased the ALARM IT, START IT, or MAX IT system. This manual also supports the 1 Way Remote
that is included with your RF Kit. There are certain features listed in this manual that may not be
available for your system. There may also be features listed in this manual that require additional
installation or programming before they are active.
If you have any questions or concerns please contact the original place of purchase. For further
information you may also contact our customer support center at 888-820-3690.
Warranty Coverage
Caution:
authorized dealer. For complete warranty details visit www.firstechllc.com or the last page of this manual.
Firstech remotes carry a 1 year warranty from original date of purchase.
Warranty registration can be completed online by visiting www.firstechllc.com
registration form within 10 days of purchase. We do not include a mail in warranty registration card with
each unit – registration must be done online. To verify that an authorized dealer installed your system,
we highly recommend that you keep a copy of the original proof of purchase, such as the dealer invoice
in a safe place.
The Manufacturer’s warranty will be voided if this product is installed by anyone other than an
. Please complete the
4
Quick Reference
LED Icons – 2nd
Car Mode
Half second
Locks doors and/or arms alarm.
Once
Valet Mode
When servicing or loaning your vehicle to others, the system should be placed in Valet Mode. Valet
Mode prevents the system from remote starting and disables all alarm functions. IMPORTANT: While in
Valet mode the remote will still control power lock and unlock systems. The parking lights will not flash.
The system can be put into valet one of three ways:
1. While holding the foot brake, cycle the key to the Ignition or ‘On’ position and then back to
the ‘Off’ position 5 times within 10 seconds. The parking lights will flash once indicating that
the system has entered Valet Mode.
2. Turn the vehicle’s key to the ignition “on” position, tap the tap the Lock and Trunk butons for a half
second. The parking lights will flash once to confirm valet mode. Repeat this process to exit valet mode.
The parking lights will flash twice confirming valet mode is disabled.
3. Turn the key to the Ignition or ‘On’ position then using a 4 button remote press and release the lock
and trunk buttons together simultaneously for a half second. The vehicle parking lights will flash 1 time to
indicate the system has successfully entered valet mode.
Remote Maintenance
When the battery on your 2 Way remote is low, you will no longer receive 2 Way confirmation in
areas you usually do. Your remote will only send commands to your vehicle. The LED’s on your
2 Way remote will also fade after transmission. The only regular maintenance this system requires is
remote control battery replacement. No programming is required when replacing the battery. If you need
assistance, we recommend contacting your place of purchase.
Two Way Remotes:
Use a quarter or flat head screwdriver to pry open the remote. You can insert the quarter or flat head
screwdriver in the small slot at the bottom of the remote by the keychain loop. Carefully pry off the back
cover without damaging the circuit board. Your battery size should be listed on the sticker on the remote.
(Battery size: 2 x CR2025) IMPORTANT: Be sure to observe correct polarity when installing the battery.
One Way Remotes:
Use a quarter or flat head screwdriver to pry open the remote. You can insert the quarter or flat head
screwdriver in the small slot at the bottom of the remote by the keychain loop. Carefully pry off the back
cover using caution that you do not damage the circuit board. Your battery size should be listed on the
sticker on the remote. Battery size: 2 x CR2025) IMPORTANT: Be sure to observe correct polarity when
installing the battery.
2 Way Remote Button Functions
Button(s) Duration Function LED Icons
3.5 seconds
Panic/vehicle locater (flashes vehicle’s
parking lights and sounds siren and horn).
Chirp(s)
N/A
5
Half second Unlocks doors and/or disarms alarm.
Turns the silent mode on or off. If on, the Unlock and Trunk
The LED’s will change to green.
Twice
2.5 seconds Resets the run time or turbo timer Three
Aux 1. Triggers the auxiliary 1 output
(most commonly used for rear defrost or
window roll-down).
Trunk release. Triggers the trunk release
output and opens the vehicle’s trunk.
Aux 2. Triggers the auxiliary 2 output
(most commonly used for rear defrost or
window roll-down).
Activates the remote start. Repeat and
remote start will shut off. Will activate
Stop and Go Mode if held when vehicle is
running with the key.
Turns siren chirps on/off (Note: With the
siren chirps off, it will still sound in the
event the alarm is triggered).
Option programming menu 1 - Installers
Only.
Valet mode (see Valet Mode Section for
details)
Hold these two buttons to turn your shock
or FT-DAS on or off
Drive lock. Activates ignition controlled
door locks.
Option programming menu 2 - Installers
Only.
Activates passive arming (vehicle will
arm/lock 30 seconds after the vehicle is
disarmed)
Activates timer start mode. Timer start
mode has multiple programmable
settings: duration settings, temperature
settings and self start settings.
nd
Puts your remote into 2
can control another vehicle with the same
remote as long as it has the same RF Kit
installed.
Car Mode. You
Half second
2.5 seconds
Half second
2.5 seconds
Half second
2.5 seconds
Half second
2.5 seconds
Half second
2.5 seconds
Half second
Half second
2.5 seconds
Once
Twice
Once
Once On /
Twice Off
Once On /
Twice Off
Once
Once On /
Twice Off
Once On /
Twice Off
Once On /
Twice Off
Once
Once On /
Twice Off
Once On /
Twice Off
Once On /
Twice Off
Half second
2.5 seconds
Remote Option Menu Table
Feature
Silent Mode
Turns Feature
On or Off
Activates the built in Turbo Timer function.
Additional installation is required when
using this feature on automatic
transmission vehicle’s.
Car Check (updates vehicle status on
remote) / Secure Auxiliary
Button
Duration
2.5
seconds
Remote
Chirp(s)
One Off
LED’s will change to red. Repeat to turn silent mode off.
Once On /
Twice Off
Twice
Function / Description
6
Remote LED Functions
Event
LED Icon
LED Duration
Chirp(s)
75 Percent
confirmations
confirmations
Your remote will communicate to and from your vehicle while in range. The unique icon LED design will
display LED’s indicating lock/unlock status, remote start confirmation, remaining run time and much
more.
Runtime Remaining:
100 Percent
Runtime Remaining:
Runtime Remaining:
50 Percent
Runtime Remaining:
25 Percent
All command
All error
Low Battery Warning Fade
Once every 5 seconds Five times
Once every 5 seconds N/A
Once every 5 seconds N/A
Once every 5 seconds N/A
Once or Twice depending on function
The icon LED’s will blink according to
which button(s) caused the error.
depending on function
Once or Twice
Three chirps
1 Way Remote Button Functions
Button Duration
Additional
Programming
Required
Function / Description
Half second no Locks doors and/or arms alarm.
3.5 seconds no Panic/vehicle locater (flashes vehicle’s parking lights and sounds siren and horn).
Half second no Unlocks doors and/or disarms alarm.
Half second no
2.5 seconds no Trunk release. Triggers the trunk release output and opens the vehicle’s trunk.
Half second no
2.5 seconds no Activates the remote start. Repeat and remote start will shut off.
Half second no
2.5 seconds no Option programming menu 1 - Installers Only.
Half second no Valet Mode (see Valet Mode Section for details)
2.5 seconds no Turns the shock sensor on/off. (Alarm or Alarm/Starter systems only)
Aux 1. Triggers the auxiliary 1 output (most commonly used for rear defrost or window
roll-down).
Aux 2. Triggers the auxiliary 2 output (most commonly used for rear defrost or window
roll-down).
Turns siren chirps on/off (Note: With the siren chirps off, it will still sound in the event the
alarm is triggered).
Half second yes Drive lock. Activates ignition controlled door locks.
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.