First Alert FA210RF User Manual

USER GUIDE

Keypad Features

• Contains a display that provides 2-digit numeric for

zone identification and pre-designated English language prompts (e.g., “ALARM”, “AWAY”, “STAY”, “CHECK”, etc.) for indicating system status. See figure 1.

• Contains a green “READY” LED that lights when

the system is ready to arm (no zone faults are present).

• Contains a red “ARMED” LED that lights when the

system is armed.

• Allows panic alarm activation. The panic alarms

are activated by pressing key pairs [1] & [*], [3] & [#], or [*] & [#]. Whether these panic keys function and the type of panic alarms they will produce is determined by the control panel’s capability and programming. (Check with your installer for the

availability and type of alarm of these panic keys).

• Contains function keys that are continuously

backlit for ease in use. (Check the User’s Manual that accompanies the control panel for detailed instructions on the use of these keys).

K3130-2 6/98

FA210RF

Keypad/Transceiver

First Alert

NO AC

AWAY

CHIME

STAY

BAT

INSTANT

ALARM

BYPASS

CHECK

Professional

FIRE

NOT READY

MAXIMUM TEST BYPASS

INSTANT CODE CHIME

Figure 1: FA210RF Keypad/Transceiver

• Contains a Piezo-electric sounder that pulses for fire alarms and sounds continuously for burglary and audible panic alarms.

ARMED

READY

OFF AWAY STAY

123

456

789

READY

PANIC

User Mode

This mode gives the you the capability of enabling and disabling individual wireless keys that have been directly programmed into the FA210RF. This is particularly useful if a user loses a wireless key.

Enter the User Mode

Changing Status of a Transmitter

Exiting the User Mode

This mode may only be accessed if the FA210RF is powered up for at least 1 minute

wireless keys programmed directly into the FA210RF may be enabled and disabled using this mode

Only

Press the 1 & 3 keys simultaneously on the FA210RF for a few seconds.

The display will show “dE” and a “-” flashing alternately. Enter the number of the wireless key transmitter (1-8).

The display then shows “d” with the wireless key number you entered and a 1 or 0 flashing alternately. A 1 indicates the wireless key is enabled, a 0 indicates disabled. Enter 1 to enable or 0 to disable the wireless key. All wireless keys are defaulted to 1 (enabled).

Press the [✳] to accept the entry. Repeat the procedure for all the wireless keys you desire to change the status.

To exit the mode press the [✳] when the display is showing “dE” and a “–” flashing alternately.

175 Eileen Way, Syosset, N.Y. 11791

¬.¢Tl

K3130-2 6/98