Recommended use: This product is intended for use as a skin antiseptic. It is for
external use only.
SECTION 2: HAZARDOUS IDENTIFICATION
Hazard Class/Category: Flammable Liquid – 3
Eye Irritation – 2B
Hazard Symbol:
Signal Word: Warning
Hazard Statements: Flammable liquid and vapor. (H226)
Causes eye irritation. (H320)
Precautionary statements:
General: Keep out of reach of children. (P102)
Eyes: IF IN EYES: Rinse cautiously with water for several minutes.
If eye irritation persists: Get medical advice/attention.
(P305+P338) (P337+P313)
SECTION 3: INFORMATION ON INGREDIENTS
OSHA Standard Format
Page 2
SAFETY DATA SHEET
SECTION 4: FIRST-AID MEASURES
Emergency first aid procedures by route of exposure:
Inhalation: If symptoms are experience, remove source of contamination or move victim to fresh air.
If affected person is not breathing, apply artificial respiration. If breathing is difficult, give oxygen.
Seek medical attention.
Ingestion: Do not induce vomiting. If the material is swallowed have victim drink 1-3 glasses of
water to dilute stomach contents. Seek medical attention or advice.
Skin: If irritation is experienced, rinse with water. If irritation persists, seek medical attention.
Eyes: Rinse eye s with water for 15 minutes holding the eye open. Seek medical attention if irritation persists
SECTION 5: FIRE-FIGHTING MEASURES
Flammability Classification: Flammable Liquid ΙB Extinguishing Media: Use methods appropriate
for the surrounding fire. Consider water spray or fog, carbon dioxide, dry chemical powder, or
alcohol resistant foam.
Products of Combustion: Upon decomposition this product may emit carbon dioxide, carbon
monoxide and/or low molecular weight hydrocarbons.
Fire Fighting Equipment/Instructions: Wear protective clothing and equipment suitable for the
surrounding fire, including helmet, facemask, and self contained breathing apparatus.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Personal Precautions: For large spills wear gloves, safety glasses and when levels exceed OSHA
PEL use appropriate NIOSH approved respiratory protection. Keep unnecessary personnel away.
Eliminate all sources of ignition or flammables that may come into contact with a spill of this material.
Environmental Precautions: Prevent discharge to open waters.
Method for Containment: Absorb spilled liquid in suitable non-flammable inert material such as
clay, vermiculite or diatomaceous earth.
Methods for Clean-Up: Ventilate area of leak or spill. Use spark-proof tools to sweep or scrape up
and containerize in approved chemical waste container. Wash spill area with water.
SECTION 7: HANDLING AND STORAGE
Handling: Keep away from heat, sparks and flame. Prevent contact with eyes. Use in well ventilated
area.
OSHA Standard Format
Page 3
SAFETY DATA SHEET
Storage: Keep the container tightly closed and in a cool, well ventilated place.
SECTION 8: EXPOSURE CONTROLS
Isopropyl Alcohol (67-63-0)
ACGIH: 200 ppm TWA
OSHA: 400 ppm TWA; 980 mg/m3 TWA
Engineering Controls: Normal room ventilation is usual l y adequ ate und er nor mal
use.
Personal Protective Equipment (PPE):
Eye/Face Protection: None needed under normal use – Wear goggles is exposed
to unusual amount and splashing
Skin Protection: None needed under normal use -- Wear overalls or apron if
splashing is possible
Respiratory Protection: May be needed if vapor concentrations are high.
General Hygiene Considerations: None needed under normal use.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Non-woven cloth saturated with liquid. There may be some free liquid in packaging.
Appearance/Color: Clear
Odor: Alcohol
PH: Not Available.
Vapor Density: 2.1 (air=1)
Boiling Point: 80°C
Vapor Pressure: No data
Melting Point: No data
Freezing Point: Not Available
Flammability Properties (see section 5)
Solubility (in water): Soluble
Specific Gravity @ 25°C: 0.88-0.92
Evaporation Rate: Not Available
Octanol/Water partition coefficient : Not Available
Auto-ignition temperature: Not Available
Decomposition temperature: Not Available
SECTION 10: STABILITY AND REACTIVITY
Stability: Stable under normal ambient temperatures 70°C (21°C)
Condition to Avoid: Avoid excessive heat or sources of ignition.
Incompatible Materials: This product reacts with strong acid, strong bases, and oxidizing agents.
Hazardous Decomposition: Upon decomposition, this product evolves carbon monoxide, carbon
Hazardous Reactions: Hazardous polymerization will not occur.
SECTION 11: TOXICOLOGICAL INFORMATION
ACUTE EFFECTS:
A: General Product information
Product contains isopropyl alcohol.
B: Acute ToxicityLow order of acute toxicity is possible.
CHRONIC EFFECTS: Component
Isopropyl Alcohol (67-63-0) -- This product is not expected to cause long term adverse effects
Carcinogenicity: ACGIH A4 – Not Classifiable as a Human Carcinogen
Neurotoxicity: No information available
Mutagenicity: No information available for product.
Reproductive: This product is not expected to cause reproductive health effects
Developmental: This product is not expected to cause reproductive health effects.
Target Organs: When consumed, ethyl alcohol can target the respiratory system, skin, eyes, CNS,
liver, blood and reproductive system.
SECTION 12: ECOLOGICAL INFORMATION
Solutions of alcohols are toxic to aquatic life at moderate to low concentrations. No long-term
ecological effects are likely. Concentrated solutions of alcohols and surfactants may cause damage
to aquatic and terrestrial plants.
SECTION 13: DISPOSAL CONSIDERATIONS
Dispose in accordance with federal state and local regulations. Labels should not be removed from
containers until they have been cleaned. Do not cut, puncture or weld near container. Do not
incinerate closed containers. Empty containers may contain hazardous residues. Dispose of
containers with care.
SECTION 14: TRANSPORATION INFORMATION
CFR 172.102 Special Provision 47
OSHA Standard Format
Page 5
SAFETY DATA SHEET
IATA
Not Regulated as Hazardous Material under IATA Sec. 4.4
DOT/IATA/IMDG Special Provisions: (DOT) Mixtures of solids that are not subject to this
subchapter and flammable liquids may be transported under this entry without first applying the
classification criteria of Division 4.1, provided there is no free liquid visible at the time the material is
loaded or at the time the packaging or transport unit is closed. Except when the liquids are fully
absorbed in solid material contained in sealed bags, for single packagings, each packaging must
correspond to a design type that has passed a leakproofness test at the Packing Group II level.
Small inner packagings consisting of sealed packets and articles containing less than 10 mL of a
Class 3 liquid in Packing Group II or III absorbed onto a solid material are not subject to this
subchapter provided there is no free liquid in the packet or article. (IATA) Small inner packagings
consisting of sealed packets or articles containing less than 10 mL of a Packing Group II or III
flammable liquid absorbed into a solid material are not subject to these Regulations provided there
is no free liquid in the packet or article. (IMDG) Sealed packets containing 10 ml or less of Class 3
flammable liquids in Packing Group II or III which are absorbed into a solid with no free liquid at the
time of shipment are not regulated.
OSHA Standard Format
Page 6
SAFETY DATA SHEET
SECTION 15: REGULATORY INFORMATION
DOT / USA
Product Description: Solid Contai ning Flammable Liquid n.o.s. (Isopropanol)
SECTION 16: OTHER INFORMATION
Issue Date: 03-26-14
Revision Date: 12-13-16
Disclaimer:
The information provided in this SDS is correct and is to the best of our knowledge,
at the date of its publication. The information given is designed only as a guide for safe handling,
use, processing, storage, transportation, disposal and release and is not to be considered as a
warranty or quality specification. The information relates only to the specific material designated and
may not be valid for such material used in combination with any other material or in any process,
unless specified in the text.
OSHA Standard Format
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.