Firestone 2097, 2227 User Manual

PERFORMANCE SUSPENSION PARTS

2097 / 2227

30

L

EVEL

NSTALLATION INSTRUCTIONS

I

Congratulations on your purchase of a new Level Command
kit. This kit was designed to provide inflation control of your
air helper springs. This kit will be an asset to your vehicle,
meeting nearly all of your air supply needs.

Please take a few minutes to read through the instructions,
identify the components, and learn how to properly install your
Level Command kit.

60

400

200

psi

kPa

0 150

C

90

600

120

800

1000

PSI

OMMAND

NOTE ON CONNECTING THE AIR LINE TUBING:

Cut the air line tubing as squarely as possible. To connect
the air line tubing to the fittings, push the tubing into the fittings
as far as possible. If for any reason the tubing must be removed,
first release the air pressure from the air helper spring. Push the
collar toward the body of the fitting and the pull out the tubing.
To reassemble, make sure the tubing is cut squarely and push
the tubing back into the fitting.

OTE

N

:

The Level Command kit can be used with all air helper
spring products. If you are installing an air suspension system,
do not install the air line tubing to the air springs as stated in
the suspension system instruction manual. If you are adding
the Level Command kit to an existing air suspension system,
you will need to deflate the air springs and remove the air line
tubing.

P

ARTS LIST

SINGLE AIR CONTROL PANEL 1
COMPRESSOR 9285 1
RELAY HARNESS 9307 1
30 FT. AIR LINE TUBING 1
STRAIGHT FITTING 3055 1
T-FITTING 3025 2

OOLS REQUIRED

T

• 3/16"

DRILL BIT

• 1/4"

IRE CRIMPER/STRIPPER

• W

HILLIPS SCREW DRIVER

• P

:

DRILL BIT

• 3/8"

OWER DRILL

• P

LIERS

• P

TILITY KNIFE

• U

DRILL BIT

• (2) 7/16" WRENCHES • CENTER PUNCH

10 -32 x 1" MACHINE SCREW 7
10 -32 LOCK NUT 7
#10 FLAT WASHER 1
RING TERMINAL 1
WIRE CONNECTOR 2
NYLON TIE 15

4

CHECK VALVE

BACK OF

CONTROL PANEL

TO
AIR SPRINGS

FROM
COMPRESSOR