STAND-ALONE GRILL HOUSEHOLD
GAS SUPPLY CONNECTION KIT
INSTRUCTIONS
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION OR USE
GAS-SUPPLY PLUMBING REQUIREMENTS
For natural gas or a household propane system, rigid
1
/2" or 3/4" black steel pipe or local code-approved pipe
is required to conduct the gas supply to the manual
shut-off valve and quick-disconnect fi tting.
1
Note: If
/2" pipe is used with natural gas, it should
be no longer than 20' .
Important: An external valve (with a removable
key) in the gas line is necessary
for safety when the grill is not in
use. It also provides for convenient
maintenance.
A household gas-supply quick-connect hose is
supplied with Natrual gas Stand-alone grills and
available separately for propane.
The quick-connect coupling must be installed after a
gas shutoff valve. The coupling socket requires a 1/2"
male pipe nipple from the gas supply.
Quick-disconnect operation
Sleeve
Fig. 1-3 Pull sleeve back
Plug
Fig. 1-4 Pull out plug
To Connect
1. Pull socket sleeve back (Fig. 1-3).
2. Insert plug and release sleeve.
3. Push plug into socket until sleeve snaps forward.
4. Open gas valve.
To gas supply
Socket
REV 2 - 1403190720
Connect
this end to
gas supply
5. Test for leaks using soapy water solution.
To Disconnect
1. Close the shutoff valve.
2. Pull sleeve back and pull out plug (Fig. 1-4).
GAS SUPPLY AND MANIFOLD PRESSURES
Quick-disconnect
hose
Fig. 1-2 - Household-gas outdoor
connector
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
For natural gas - Normal 7" water column (w.c.), minimum 5"
w.c., maximum 10-
For propane gas - Normal 11" w.c., minimum 8" w.c., maximum
13" w.c.
1
/2" w.c.
1
L-C2-284