Fire Magic Echelon Diamond Master Switch Replacement User Manual

MASTER SWITCH

Part # 24182-46

INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.

This master switch is for replacement in an Echelon Diamond
Grill. To install, follow the steps below:

1. Ensure the grill is completely cool, the knobs are in the
off position, the gas supply to your grill is turned off, the
master switch is off, and the power supply is disconnected.

2. Pull off the control knobs. Slowly lift away the lighted bezels to clear

the valve stems, and carefully disconnect the wires found on the
back of the bezels (use your fi ngernail).

3. Remove the smoker drawer and drip tray.

Disconnect

4. Unscrew and remove the control panel screws and washers. Lift

the control panel up and outward, allowing it to rest on the internal
chain(s).

5. Locate the master switch on the right side of the exposed control
panel, and disconnect the wire harness (see Fig. 1-1).

6. From the inside of the control panel, use pliers or an open ended
wrench to loosen the nut that is securing the master switch in
place. Use your hand to completely remove the nut. See Fig. 1-2.

7. Remove the master switch.

8. Your grill may have a knockout around the now exposed master

switch opening. If so, use your fi ngers or a tool to completely
remove the knockout (see Fig. 1-3). If not, proceed to the
following step.

Fig. 1-1 Master switch location

Remove nut

Fig. 1-2 Remove master switch nut

Knockout ring

ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746

REV 0 - 1112021032

Fig. 1-3 Remove knockout ring (if applicable)

1

L-C2-382

9. Ensuring the O-ring is fl at against the master switch; insert the
new master switch into the opening. Use the nut provided with
your new master switch to hand tighten the switch in place. Use
pliers or an open end wrench to secure. Reference Fig. 2-1.

10. Connect the wire harness (see Fig. 2-2).

11. Connect the power supply, & test your new master switch prior

to replacing the control panel.

12. Set the control panel back over the front lip of the grill, being
sure that the lid-closed-sensor protrudes through the hole on
the upper right of the control panel (if applicable). Replace
the screws.

13. Replace the smoker drawer, drip tray, lighted bezels, and
control knobs.

14. With the knobs in the OFF position, turn on the gas supply.

Fig. 2-1 Installing master switch

Connect

wire harness

Fig. 2-2 Connect wire harness

REV 0 - 1112021032

2

L-C2-382