Fire Magic E790S4LAN62W, E1060S4EAP71, E660S4AAN62 Quick Start

ECHELON

diamond series

Robert H. Peterson Co.

Outdoor Stand Alone

Gas Grill

Quick Start Guide

CAUTION: For your safety read the installation instructions and owner’s manual provided with the grill.

1-Safety

INSTALLER: Leave these instructions with consumer. CONSUMER: Retain for future reference.

This grill must be installed in accordance with local codes and ordinances, or, in the absence of local codes, with either the latest National Fuel Gas Code (ANSI Z223.1/NFPA 54), and Natural Gas and Propane Storage and Handling Installation Code (CSA-B149.1).

This appliance and its individual shutoff valves must be disconnected from the gas-supply piping system when testing the system at pressures in excess of ½ psig. This appliance must be isolated from the gas-supply piping system by closing its dedicated manual shutoff valve during any pressure testing of the gas-supply system at pressures up to and including ½ psig.

This grill is designed for outdoor use only. DO NOT use this grill under unprotected ﬂ ammable surfaces. DO NOT use this grill inside a building, garage, enclosed area, or an unprotected covered area (see paragraph below). DO NOT use this grill in or on a recreational vehicle or boat.

If installed or used under a patio roof, the cooking grid area must be fully covered by an exhaust hood with a vent. An exhaust fan with a rating of 1,000 CFM (cubic feet per minute) (472 liters per second) or more may be necessary to effectively remove smoke and other cooking by-products from the area under the hood. Fire Magic Vent

Hoods are available to meet this requirement. This outdoor grill must not be used under overhead unprotected combustible construction. THIS UNIT MUST NOT BE LOCATED IN A FULLY ENCLOSED AREA OF ANY KIND.

2-Unpacking

Carefully unpack the grill, removing all packing material and protective ﬁ lm. Verify that all parts have arrived undamaged by consulting the parts list in the owner’s manual. Remove foam packed hardware from oven area. (See Fig. 2-1.)

Consult the parts list in the owner’s manual. If any parts are missing or damaged, immediately contact the Fire Magic dealer before beginning installation.

Important: The 2 shipping screws must be removed prior to removing the unit from

the wooden pallet. The screw located on the bottom left side of the unit is

accessed by opening the door. The screw located on the bottom right side of the unit is accessed by removing the lower drawer.

To remove the drawer; pull it completely out. Release the drawer from the

drawer slides by pressing the black lever down on the right side, and up on the left side.

3-Installation

NOTE: THE CONTROL PANEL DOES NOT NEED TO BE REMOVED

FOR INSTALLATION. IF REMOVAL IS REQUIRED IT MUST BE DONE WITH CAUTION BY A QUALIFIED PROFESSIONAL SERVICE TECHNICIAN, TO PREVENT ANY POSSIBLE WIRE DISCONNECTIONS.

Location

INCORRECT

Rear oven lid vent

Remove plastic

zip-ties

Lift out foam packed hardware

Fig. 2-1

CORRECT

Locate the grill on a ﬂ at level surface with 18” clearance from the oven back and sides to any combustible material or construction.

CAUTION: Wind blowing into or across the rear oven lid vent (Fig.

3-1) can cause poor performance and/or dangerous overheating. Orient the grill so that the prevailing wind blows toward the front of the grill (Fig. 3-2).

CAUTION: To prevent dangerous overheating, the rear of the unit must have

a minimum clearance of 4” (10.2 cm) from any backsplash/wall.

Connect Gas supply

These quick start instructions assume a

propane cylinder conﬁ gured unit. See main instructions for natural gas or household propane conﬁ gured units.

Place approved propane 20lb cylinder in tank tray and lock holder in position (Fig. 3-3).

Connect quick coupler hose and regulator supplied with unit to propane cylinder (Fig. 3-4).

Set all burner control valves to OFF and open gas source control valve.

Follow the lighting instructions on the reverse side of this guide.

Proper grill airﬂ ow must be maintained as shown in Fig. 3-5.

REV 3 - 1210171002

Sideburner

shelf (if

equipped)

Tool holder

Quick

coupler

Tank tray latch

SET

Fig. 3-3

YOU MUST PROTECT REAR OVEN

VENT FROM PREVAILING WIND

Fig. 3-1

Regulator

Backburner

cover (if

equipped)

Paper towel

holder

Propane

cylinder (tank)

Vent

Hose

Fig. 3-4 Type I Acme thread quick coupler

Ventilation diagram

Fig. 3-5

Hand nut with Acme thread

PLACE GRILL SO PREVAILING WIND

BLOWS TOWARD FRONT OF GRILL

Fig. 3-2

Brass Acme thread ﬁ tting

Liquid level indicator (optional)

To connect the regulator/ hose assembly to the propane-gas cylinder valve ﬁ tting: Press the hand nut

on the regulator over the Acme thread ﬁ tting on the cylinder valve. Turn the hand nut clockwise to engage the threads and tighten until snug.

Hand wheel

QCC Type 1 valve

Pressure relief valve

L-C2-336

Note: For infrared burner equipped

grills; see detailed instructions included in your owners manual.

Cooking Grid

4-Grill Setup

Parts Placement Checklist

Place the following items according to their position and orientation in Fig. 4-1:

Backburner

cover

Warming

rack

Sideburner

lid

Flavor Grid

(not with IR)

E-burner *

(comes pre-

installed)

Rotisserie

rod storage

ring

Flavor grids, cooking grids, heat zone dividers, backburner cover, warming rack, meat probe.

Leave pre-installed E-burners in place to maintain proper alignment.

Backburner Cover

Hook the backburner cover over the top of the backburner to protect the backburner from grease, dust and dirt when it is not in use. Remove before use.

Warming Rack

The warming rack comes pre-installed. Remove zip ties before use. Consult the owner’s manual to remove or replace.

Shelf/Sideburner (if equipped)

Align the four (4) holes in the shelf with the four (4) holes in the side of the cart while aligning and engaging the burner venturi with the oriﬁ ce (Fig. 4-2). Insert the four (4) screw (provided) into the holes and tighten. Connect the spark wire to ignitor electrode (Fig. 4-2). Open sideburner

lid, set cap on burner, and set grid into shelf.

Ignitor

electrode

Drip tray

liners

Cotter

Drip tray (with

lighting instructions)

Door

Fig. 4-1

Read setting here

Read setting

(OFF position shown)

here

TURN OFF

To Turn OFF

Press knob in to turn

Fig. 5-1 - Burner valve control knob

OFF

Gas Flow Indicator

LOW

To Turn ON

T O TURN ON

LIGHT

HIGH to

Use

LIGHT

HI (high) to light

For your convenience and safety;

when the control knob is in the ON position, the gas ﬂ ow indicator will change from blue to red. (Red

indicates gas ﬂ ow.) See Fig. 5-1.

WHEN OPERATING THIS

APPLIANCE WITH PROPANE, ALL

INSTRUCTIONS AND WARNINGS

MUST BE OBSERVED. FAILURE TO

DO SO MAY RESULT IN A FIRE OR

EXPLOSION CAUSING SERIOUS

INJURY OR DEATH.

The master switch (Fig. 5-2) controls

the power to all lights, igniters, and the

thermometer. It allows the power to be

turned on or off for safety and convenience.

The switch will need to be turned on prior to

each grill use, and turned off after each use.

Meat probe

Drawers

5-Test

1. Open the lid and remove any cover(s) of the burner(s) to be lit.

2. Turn all gas control knobs to the OFF position.

3. Turn the gas-supply valve on.

4. Depress the desired control knob for 5 seconds, then, while pressing turn it

CAUTION: If burner does not light within 5 seconds, IMMEDIATELY depress the

backburner

control knob

(if equipped)

Left main burner

control knob

Center left main

The burner ports

and carry-over slots

Venturi

must be kept clean to

ensure proper ignition

and operation.

Spark

wire

counterclockwise to the HI LIGHT position. Once the burner lights, release the control knob. (Repeat this step for each additional burner.)

knob and turn it to the OFF position. Wait 5 minutes before repeating step 4. If the burner does not light after repeated attempts, refer to the Lighting Instructions in your Owners Manual.

Left

Sideburner

control knob

burner

control knob

Center right main burner

control knob

Pull-out drip

tray

Digital thermometer

Smoker drawer

burner control

knob

Wood chip

Power hood control switch (if equipped)

main burner control knob

tray

Air shutter

Screws

Oriﬁ ce

Fig. 4-2

Fig. 5-2

Right

Right backburner

control knob

(if equipped)

Meat probe

Master

switch

6-Propane Safety

Gas Cylinders

IMPORTANT: READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER.

READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE GAS FOUND IN

YOUR OWNERS MANUAL.

REV 3 - 1210171002

L-C2-336

Fire Magic E790S4LAN62W, E1060S4EAP71, E660S4AAN62 Quick Start

Specifications and Main Features

Frequently Asked Questions

User Manual