Fire Magic DC-WK-03 User Manual

ISLAND ENCLOSURE
WHEEL KIT
Model # DC-WK-03
INSTALLER: Leave these instructions with consumer. CONSUMER: Retain for future reference.
This wheel kit is only for installation on Fire Magic Island Enclosure models: DC430-CBR-75SM DC790-CBR-108SM
WHEN INSTALLING ON AN UNASSEMBLED ISLAND ENCLOSURE
Prior to assembling the island enclosure, install the wheel kit per the steps below.
1. Carefully place the left island wall upside down.
2. Align the left wheel assembly and fasten using
9
the included hardware and a wrench or equivalent (Fig. 1-2).
Note: The wheel assembly must stay level when
being installed.
3. Repeat for the right island wall using the right wheel assembly as shown in Fig. 1-3.
/16" open-end
(Left wheel assembly) (Right wheel assembly)
Fig. 1-1 Overall install detail
Note: The wheel assembly must stay level when
being installed.
4. Follow your island instruction manual to complete island installation.
Important: Before installing the countertop, use
the included hardware to properly secure the wheel assemblies to the front and rear walls.
(Keep level)
Left side wall shown
(upside down)
(Exterior-side)
Fig. 1-2 Install left wheel assembly to bottom of left side wall
Right side wall shown
(upside down)
(Keep level)
(Exterior-side)
REV 1 - 1504090745
Fig. 1-3 Install right wheel assembly to bottom of right side wall
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
1
L-C2-413
WHEN INSTALLING ON AN ASSEMBLED ISLAND ENCLOSURE
WARNING: Use extreme care when installing this
wheel kit on an existing island that has already been fully assembled. Use two or more people when handling the island enclosure.
1. Remove any appliances, doors, drawers, and countertop leaving only the island frame fully­assembled. See Fig. 2-1.
WARNING: Take into consideration any gas supply
plumbing, electrical wires, etc. when moving/removing these items.
2. Carefully place two 2x4's under the island enclosure as shown in Fig. 2-2. (Keep clear of any levelers.)
3. Remove all levelers (see Fig. 2-3) and install the left wheel assembly to the left side of the enclosure
9
using the included hardware and a wrench or equivalent (see Fig. 2-4).
/16" open-end
DC430 model
shown
Fig. 2-1 Remove appliances, doors drawers, etc.
Fig. 2-2
Left wheel
assembly
2x4
Place 2x4's under island enclosure
2x4
(2x4's not shown)
Fig. 2-3 Remove Levelers
2x4
REV 1 - 1504090745
Fig. 2-4 Install left wheel assembly
2
L-C2-413
Loading...
+ 2 hidden pages