Fire Magic 3682 User Manual

WARMING RACK EXTENDER

Model # 3682

INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.

COOKING AREA: 14" x 7"

This warming rack extender is for use with the following
grill series only: A530, A660, A790,
E660, E790, & E1060

ASSEMBLY & INSTALLATION

1. Ensure the grill is completely cool, the knobs
are in the off position, and the gas supply to
your grill is turned off.

2. Wash all of the warming rack extender components

(with soap and water) before assembly.

3. To assemble, carefully slide the brackets onto the
tray as shown in Fig. 1-1 "A". Snap the brackets
in place. See Fig. 1-1 "B".

4. Open grill oven hood.

5. Position the extender above the warming rack, lower

the hooks into the rear of the rack, then lower the front.
The bottom of the extender has grooves that rest on
the front of the warming rack. See Fig. 1-2 and 1-3.

6. Repeat if additional extenders were purchased.

The extender may be removed and stored when desired.

DISASSEMBLY FOR CLEANING

It is recommended that the warming rack extender be
cleaned after each use. It can easily be disassembled
and fi t in a dishwasher.

A

Fig. 1-1 Assemble warming rack extender

B

Fig. 1-2 Install warming rack extender

align to front bar

B

A

Grooves must

when lowered

1. Remove the warming rack extender(s) from the

grill and disassemble by reversing the instructions
in step 3 above.

2. Clean as needed.

ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746

REV 0 - 1404240816

Fig. 1-3 Warming rack extender in place

1

L-C2-432