Fire Magic 3275-12 User Manual
SPARK IGNITOR REPLACEMENT FOR SIDEBURNERS
Fire Magic Sideburner Ignition Systems are
generally quite reliable. In the event that
replacement of parts is necessary, these
illustrations and instructions will simplify installation.
1. Unplug the wire or wires and remove
the old spark generator and any
brackets or spacers used for mounting.
Also, unplug the old electrode wire from
the electrode (Figure 1).
2 . Mount the new spark generator, using
the two (2) 8-32 x 5/8” screws provided.
No brackets or spacers are required.
Manifold
Mounting Bracket
Ground Wire
Part # 3199-13-1
Electrode Wire
Part # 3275-14
Electrode
Using a Phillips screwdriver, tighten the
screws until the generator is firmly
secured below the housing panel
(Figure 2).
3. Plug the new electrode wire into the electrode
and attach the ground wire under one of the
nuts securing the manifold bracket. Loop
each wire around the gas connector tubing
and plug into the spark generator (Figure 1).
Ignitor Assembly Complete
Part # 3275-12
(Includes all components listed below with
part numbers)
Spark Generator
w/lock Stem
Part # 3199-23-1
Underside View
(Figure 1)
Knob,lock-On
Part # 3199-23-02
4. Press the ignitor knob onto the ignitor stem
until it snaps into place. The knob will be
“locked” on to the stem but can be removed by
firmly lifting the knob off the stem or by placing
the blade of a screwdriver under the knob and
gently lifting. This knob can be accidentally
turned the wrong way (counterclockwise) without
damaging the ignitor knob or the spark
generator.
This manual may not be copied, photocopied,
reproduced, translated, or published in any electronic or
machine-readable form in whole or in part without prior
written approval of Robert H. Peterson Co.
Robert H. Peterson Co. • 14724 East Proctor Avenue • City of Industry, CA 91746
REV A 030105
Screws,8-32 x 5/8 (2)
Part # 3985-2105F
Spark Generator
Top View
(Figure 2)
We reserve the right to amend product
specifications without prior notice.
No. L-C2-02605
Loading...