Fire Magic 3092B FireMagic 1 Hour Automatic Timer Shut Off Valve -3092B Instructions Manual

Automatic Grill Shut-off

1-Hour Timer

Model# 3092A

INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.

Note: This timer can be installed horizontally or

vertically. See Fig. 1-1 for horizontal setup and
Fig. 1-2 for vertical setup.

Fit the Automatic Grill Shut-Off Timer in the gas supply
line before the grill. The timer accommodates 1/2" NPT
piping (both ends).

Important: Ensure you connect the gas supply to

the side marked “IN” on the timer (see
photo). It MUST NOT be fi tted within 18"
of the grill, or it will overheat, causing
damage to the timer and may result in
a leak.

Use pipe joint compound on male fi ttings attached to
the timer.

To use, set the dial (turn clockwise) to the desired time to
shut off. The dial is marked in 3 twenty minute increments
(any position in between is an estimate of that set time).
The timer dial will auto rotate (counter-clockwise) and
will shut off the gas supply when the dial reaches OFF
(i.e. the time is completed).

Important: When using the timer for periods of less

than twenty minutes, you must first set
the dial to 20 minutes (to activate), then
return (counter-clockwise) to the desired
amount of time. This will ensure proper timer
operation. See Fig. 1-1 or Fig. 1-2.

Rated up to 100,000 BTUs /

Max temperature 125°F

Gas fl ow direction

(to grill)

Gas supply

side

Turn past

20 minutes

to activate

Fig. 1-1 Horizontal setup

Timer setting

mark

(shown here

in OFF)

Timer setting mark

(shown here in OFF)

Grill
side

Time settings:
20-60 minutes

Grill
side

ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746

REV 1 - 1610190850

Turn past

20 minutes

to activate

Gas fl ow
direction

(to grill)

Gas supply side

Time settings:
20-60 minutes

Fig. 1-2 Vertical setup

1

L-C2-485