AUTOMATIC GRILL SHUT-OFF
3-HOUR TIMER INSTRUCTIONS
Rated up to 100,000 BTUs /
Max temperature 125°F
Fit the Automatic Grill Shut-Off Timer in the gas supply line before
the grill. The timer accommodates
Important: Ensure you connect the gas supply to the
side marked “IN” on the timer (see photo). It
MUST NOT be fi tted within 18" of the grill, or
it will overheat, causing damage to the timer
and may result in a leak.
Use pipe joint compound on male fi ttings attached to the timer.
To use, set the dial (turn clockwise) to the desired time to shut
off. The dial is marked in 3 one hour increments (any position
in between is an estimate of that hour). The timer dial will auto
rotate (counter-clockwise) and will shut off the gas supply when
the dial reaches OFF (i.e. the time is completed).
Important: When using the timer for periods of less than
one hour, you must fi rst set the dial to 1 hour (to
activate), then return (counter-clockwise) to the
desired amount of time. This will ensure proper
timer operation. See Fig. 1-1.
1
/2" NPT piping (both ends).
Timer setting mark
(shown here in OFF)
Gas fl ow
direction
(to grill)
Time settings: 1-3 hours
Grill
side
Turn past
1 hour
to activate
Gas supply side
Fig. 1-1
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
REV 2 - 1411100725
AUTOMATIC GRILL SHUT-OFF
3-HOUR TIMER INSTRUCTIONS
Rated up to 100,000 BTUs /
Max temperature 125°F
Fit the Automatic Grill Shut-Off Timer in the gas supply line before
the grill. The timer accommodates
Important: Ensure you connect the gas supply to the
side marked “IN” on the timer (see photo). It
MUST NOT be fi tted within 18" of the grill, or
it will overheat, causing damage to the timer
and may result in a leak.
Use pipe joint compound on male fi ttings attached to the timer.
To use, set the dial (turn clockwise) to the desired time to shut
off. The dial is marked in 3 one hour increments (any position
in between is an estimate of that hour). The timer dial will auto
rotate (counter-clockwise) and will shut off the gas supply when
the dial reaches OFF (i.e. the time is completed).
Important: When using the timer for periods of less than
one hour, you must fi rst set the dial to 1 hour (to
activate), then return (counter-clockwise) to the
desired amount of time. This will ensure proper
timer operation. See Fig. 1-1.
1
/2" NPT piping (both ends).
Timer setting mark
(shown here in OFF)
Gas fl ow
direction
(to grill)
Time settings: 1-3 hours
L-C2-323
Grill
side
Turn past
1 hour
to activate
Gas supply side
Fig. 1-1
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
REV 2 - 1411100725
L-C2-323