Fire Magic 300008 User Manual

Liner Replacement Kit

INSTALLER: Leave these instructions with consumer. CONSUMER: Retain for future reference.

Series Kit Model #

Regal I 3000-08

Regal II 3000-07

Custom I 3000-01

Custom II 3000-03

Deluxe 3000-02

Table 1

This liner is for replacement on Regal and Custom Series Grills. Installation on a Custom II model is shown here. Installation on

other models may slightly vary. To install, follow the steps below:

Custom II kit shown

Fig. 1-1 Remove grill components

(Rear wall)

1. Be sure the barbecue is completely cool and the gas is completely shut off.

2. Remove the warming rack, cooking grids, ﬂ avor grids, burners,

control panel, igniters, and oven hood (if applicable). See Fig. 1-1. Reference your owner's manual for complete removal details if needed.

Important: If the oven hood is equipped with a back burner,

the gas line and igniter wire to the back burner must be disconnected in order to remove the oven hood (if applicable).

3. Remove any nuts and bolts from the existing rear wall and discard. See Fig. 1-2.

Note: The discarded nuts and bolts will be replaced by new

nuts and bolts included with the replacement liner.

4. Clean the interior of the grill of all deposits and grease.

5. Carefully install the bottom liner as shown in Fig. 1-3.

6. Install the top liner ensuring that it rests ﬂ at against the

original liner walls (see Fig. 1-4).

7. Replace all of the components removed for this procedure.

Remove ALL

nuts and bolts

Fig. 1-2 Remove nuts and bolts

Bottom

liner

Fig. 1-3 Install bottom liner

(Top liner)

ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746

REV 0 - 1408141310

Fig. 1-4 Install top liner

L-C2-433

Specifications and Main Features