Fire Magic 12S101CA Owners Manual

Front view of charcoal grill slide-in
unit with Smoker hood and warming
rack.

GOURMET STAINLESS STEEL

CHARCOAL GRILL
w/ SMOKER HOOD

12 & 14 BUILT-IN SERIES

22 & 24 PORTABLE SERIES

COVERS MODEL NO.’S:
12-SCOXX-XA 22-SCOX-61
14-SCOXX-XA 24-SCOX-61
22-SCOXX-11

FOR YOUR SAFETY

1. Do not store or use gasoline, or other

fl ammable vapors and liquids, including
propane cylinders, in the vicinity of
this or any other appliance.

BRICK OPENING REQUIREMENTS

Front view of charcoal grill cart unit with Gourmet hood
and warming rack.

12 SERIES: 19 3/4" depth, 26 1/4" width, 12" height
14 SERIES: 19 3/4" depth, 32 1/4" width, 12" height

Simple to use, this elegant stainless steel charcoal grill has the added benefi t of an adjustable
charcoal pan to allow you to change the height of the charcoal while cooking, and it gives you the
ability to add fuel without having to remove the cooking grids. This enables the outdoor chef to be
in complete control of cooking heat at the grilling surface.

WARNING

Built-in models must be installed in masonry or other type of fi reproof enclosure. The unit is not
insulated and therefore must be installed with 18" of side and back clearance from unprotected

combustible materials such as wood, plastic or stucco with wood framing.

Do not install this unit under unprotected fl ammable
surfaces. Do not install or use this appliance inside a
building, garage, or any other covered area, including
recreational vehicles or boats.

Carefully unpack your grill and check the parts. If you
have purchased a slide-in, simply slide the unit into your
grill opening. Next, fi t the crank handle into the hole on
the front right side of the face. Aligning it carefully, screw
it into the nut on the frame (see Fig. 1-1). After fi tting,
crank the handle to ensure the charcoal lifter moves up
and down freely.

Installing the crank handle

Align crank handle

ALIGN CRANK HANDLE
WITH NUT & SCREW IN

with nut & screw in

Fig. 1-1

REV 2 - 0711071126

ROBERT H. PETERSON CO. • 14724 East Proctor Avenue, City of Industry, California 91746

1

L-C2-18507

Warming Rack

Stabilizer Bar

Side Bracket (2)

Reinforcement Screws

Barbecue Slots (2)

Hanging Brackets (2)

WARNING

Improper installation, adjustment, alteration, service, or maintenance can cause injury or

property damage. Refer to this manual. For assistance or additional information, consult a

qualifi ed, professional installer, or service agency.

SMOKER HOOD

When it’s not protecting your Fire Magic
greatly expand your grilling repertoire. Now you will be able to roast, bake, and smoke foods, adding
the special fl avor and tenderness that only slow cooking in a closed oven can produce (see below
for installation information).

Installation of your gourmet smoker hood on your
Fire Magic® grill couldn’t be simpler. First, remove
the cooking grids from the grill. Then place the
oven in the grill without the grids, making sure
that the left and right side brackets slide into the
slots on both sides of the grill. Next insert the
reinforcement screws into the bracket on either
side of the grill to secure the smoker hood to the
unit. Now place the rear portion of the warming
rack into the warming rack hanging brackets and
slide the stabilizer bar into the allotted space
adjacent to the screws used to secure the unit.
Finally replace the grids inside the oven. You’re
done!

®

gas grill from the elements, your new smoker hood will

Fig. 2-1

Warming rack

Hanging brackets (2)

Stabilizer bar

Side bracket (2)

Grill slots (2)

Reinforcement screws

Maintenance of the gourmet stainless steel charcoal grill w/smoker hood is just as simple. Occasionally
apply a few drops of light household oil to the hinges to keep them working smoothly.

®

Clean all surfaces with Fire Magic

foaming grill and grill cleaner or any household oven cleaner,

following the manufacturer’s instructions for porcelain or stainless steel. Never use acid chemicals
to clean porcelain or glass surfaces.

For thorough cleaning, the oven handle
assembly may be removed (see Fig. 2-2).

Fig. 2-2

For stainless steel restoration and finish
maintenance, see the instructions enclosed with

Fire Magic® products for stainless steel.

REV 2 - 0711071126

2

L-C2-18507