Fire-Lite ACC-25-50ZS User Manual
AUDIO•COMMAND•CENTER•25/50ZS Operating Instructions
NORMAL - Only the green POWER ON LED is on. All other
LEDs are off.
PANEL - The key to open the panel can be found at this
location:_____________________________________
WHEN AUDIBLE DEVICES ARE SOUNDING -
FOR AN ALARM:
Evacuate the protected area.
1)
Notify the monitoring service and/or the Fire Department
2)
immediately . Tell them briefly what happened and what your
current status is.
If the Fire Department is responding, be prepared to provide
3)
directions to arriving firefighters.
FOR TROUBLE ONLY:
Notify the monitoring service and/or Fire Department if the
1)
host panel is connected to either one, and tell them what is
happening.
Silence local piezo by pressing the TROUBLE SILENCE key .
2)
The yellow SYSTEM TROUBLE LED will remain on. Contact
authorized service personnel immediately!
TO PAGE IN STANDBY or ALARM
Press the ALL-CALL switch to page to all zones or the desired
1)
Zone switch(es). This will override the evacuation tone/
message if panel is in alarm
Key the microphone by pressing switch on side of microphone.
2)
Speak clearly into microphone.
3)
Release microphone switch and press the ALL-CALL switch
4)
or Zone switch(es) to continue evacuation tone/message.
INSTRUCTIONS
Manual Message Control:
• Single Zone Operation - press the desired
message switch.
Paging:
• ALL-CALL, press the ALL-CALL Switch
and then the microphone Push-to-T alk
switch.
T r ouble Silence:
• Press to turn off the local trouble sounder
Paging in Standby or Alarm:
• Paging by Zone - press the desired Zone
switch(es) and then the microphone Push-toTalk switch. Speak clearly into microphone.
• All-Call - refer to description above.
POWER FAILURE OR BROWNOUT - The AC power LED,
located on the main circuit board, will go out for AC fail or brownout.
SYSTEM TROUBLE LED and the local piezo will turn on for either
condition. Contact authorized service personnel immediately .
(Refer to Local Service Representative block below).
W ARNING!
Do not allow trouble conditions to remain logged
in the system. Protection that the system offers
has been compromised, or eliminated when a
trouble condition exists.
Local Service Representative
Name:______________________________
Address:____________________________
Telephone:__________________________
Frame and mount adjacent to the control panel.
Deactivation of Zone(s) in Alarm:
• Press the activated (green) Zone switch(es).
The LED(s) change to yellow for trouble. To
reactivate, press the Zone switch(es) again.
Refer to the AUDIO•COMMAND•CENTER•25/50ZS
T echnical Manual P/N 51889 for more det ails.
Document 52170 Rev. B ECN 06-592 8/27/07
Loading...