Fire Cam 1080 User Manual

fire cam 1080

user manual

OVERVIEW

1. LED

2. Power / Shutter

3. Rear Cap

4. Mode Switch

5. USB

6. Micro SD Card Slot

7. Battery

8. Microphone

9. 1080P / 720P Mode Switch

INITIAL SET UP

1. Make sure the Fire Cam1080 is OFF before adding or removing the memory card.

2. Unscrew the rear cap located at the back of the Fire Cam 1080.

3. A CLASS 6 OR 10 MICRO SDHC SD CARD IS REQUIRED. Install the SD memory card
(max up to 64GB[Fat32 format]) into the rear slot.

To insert the micro SD card, slide the micro SD card into the card slot on the back of
the Fire Cam 1080 with the card label facing down. The micro SD card will click into
place once it is inserted. Then replace the rear cap.

4. If no micro SD memory is inserted in the Fire Cam 1080, the LED on top of the
camera will blink red and blue.

5. When using a micro SD memory card in the Fire Cam 1080, there should be no
data from other devices on the card. If you are using a micro SD memory
card for the first time in the Fire Cam 1080, first you should format the card in your
computer (FAT32 FORMAT).

WATER RESISTANT AUDIO CAP (WITH HOLE) is used for standard
firefighting conditions and enables the camera to be water resistant
but NOT waterproof underwater. The hole allows audio to enter the
unit for recording.

WATERPROOF CAP (WITH NO HOLE / NO AUDIO) is used for
heavy water conditions which can submerge the camera. You will need

to use 2 Orings and add some silicon grease from time to time, especially
before using underwater. Make sure the rear WATERPROOF CAP (no hole)
is firmly closed.

Charging the battery

Unscrew the rear cap located at the rear of the camera and Plug the USB charger into the
camera. The charging LED is on while charging and will turn off when the battery is fully
charged. On the first use, charge the battery 2~3 hours before use.

Take Video with Fire Cam 1080

Turn on the Fire Cam 1080 by pressing the Power/Shutter button once. The BLUE
LED will be on and the RED LED flashes. This will indicate it is in standby mode and
it will start recording automatically.

To STOP recording and save a file, simply press the button once. This will save the
file to the SD card. During operation, video files will automatically be saved

every 5 minutes. You may choose to have files saved every 5, 10, 15, 20 or 30
minutes in the Date and Time settings.

Turn OFF the Fire Cam 1080 by holding the button down for more than 2 seconds.
The RED LED flashes and the unit will beep 6 times and turn OFF.

Card slot empty

If there is no Micro SD card in the Fire Cam 1080, the red and blue LED will flash for 30
seconds, then the camera will switch off automatically.