Finish Thompson EF Series User Manual

EF Series Wall Hanger Instructions

Figure BFigure A

If you ordered the optional Wall Hanger p/n 108287 or received it in one of our kits please follow these instructions for installation &
use:

1. If using the 115v or 230v Quick Charger you may store it inside the Wall Hanger. Simply align the charger cables with the slots on
the wall hanger making sure the indicator light lines up with the hole on the front of the wall hanger. Slide the charger into place.
Charger cord plug may be stored in the slot on the right side of the Wall Hanger. See Figure A. Note: Wall Hanger may also be used
with other EF electric & air operated motors.

2. The Wall Hanger comes with 4-#10 x 2-1/2” Phillip head screws for attaching to a wall. If longer screws are needed make sure to
use the same diameter so as not to damage the wall hanger. Suggest using a piece of ½” or 5/8” plywood to install the Wall Hanger
to a wall. If not available you may attach it to a wooden stud. Care should be taken to align the center of the Wall Hanger with the
center of the stud so all 4 screws can be used. If mounting to Drywall use proper drywall fastening hardware. If mounting to a brick
or cement wall you may use 3/16” x 2-1/4” Tapcon screws. Pre-drill with a 5/32” masonary drill bit using the Wall Hanger as a guide
for screw holes.

Caution: Wall Hanger must be level to properly hold the motor & pump and prevent damage. Care should also be taken to not
over-tighten screws or damage could be done to the Wall Hanger.

3. Pump & motor can now be installed on the Wall Hanger. See Figure B.

p/n 108299