FinePrint pdfFactory Pro Office 8K User Manual
Office 8K - 8 Buttons Wireless Optical Mouse
UK
Office 8K Wireless User’s Guide
- 0 -
PDF 檔案以 "FinePrint pdfFactory Pro" 試用版建立 http://www.pdffactory.com
Office 8K - 8 Buttons Wireless Optical Mouse
UK
TWO CONDITIONS: (1) THIS
D, INCLUDING
limits a
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
ful interference to radio communication. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
e equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING
DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVE
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Federal Communications Commission Requirements
The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC Rules. These
frequency energy and, if not installed and used in accordance with the instruction, may cause harm
which can be determined by turning th
measures:
l Reorient of relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
l Consult the dealer or an experienced radio/TV technician for help.
The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
- 1 -
PDF 檔案以 "FinePrint pdfFactory Pro" 試用版建立 http://www.pdffactory.com
Office 8K - 8 Buttons Wireless Optical Mouse
UK
receiver. To make sure
For optimal performance, place the receiver at least 8 inches (20 centimeters) away
her electrical devices, such as the computer, the monitor, or external storage
Mouse should be no farther than 3.3 feet (1.0 meter) from the mouse
Switch frequency channels to prevent interference from other RF pointing devices.
I
NNTTRROODDUUCCTTIIOON
I
C
C
OONNGGRRAATTUULLAATTIIOONNSS OONN YYOOUURR PPUURRCCHHAASSE
R
R
AADDIIOO RREECCEEIIVVEERR CCAANN BBEE CCOONNVVEENNIIEENNTTLLYY PPLLAACCEEDD AANNYYWWHHEERREE TTOO GGIIVVEE YYOOUU TTHHEE FFRREEEEDDOOMM YYOOUU NNEEEEDD WWHHIILLEE WWOORRKKIINNG
N
E
Y
!! Y
OOUURR NNEEWW
RRFF--M
M
OOUUSSEE
O
O
FFFFIICCEE
K
88K
IISS EEAASSYY TTOO IINNSSTTAALLLL AANNDD OOFFFFEERRSS YYOOUU AA CCOOUUNNTTLLEESSSS OOFF UUSSEEFFUULL FFEEAATTUURREES
G
..
Connecting the RF-Mouse Receiver
The RF-Mouse receiver connects to your computer in the same way as a conventional mouse does;
allowing you to place the receiver wherever is convenient on your desktop.
1. Locate an available USB mouse port on the back of your computer.
2. Insert the USB mouse port connector into the available computer USB port.
If you want to connect an USB mouse to your computer PS2 port, you must use a USB to PS2 adapter.
Locating the RF-Mouse Receiver
Your RF-Mouse has limitations on the range or distance from its
that your mouse sends and receives properly, refer to the following instructions:
1.
from ot
drives.
2. The RFreceiver. This will ensure optimal communication between the mouse and receiver.
3. If you are working on a metallic surface, trying a mouse pad for better reception.
(See the following section for more information.)
S
T
E
.. T
HHE
- 2 -
PDF 檔案以 "FinePrint pdfFactory Pro" 試用版建立 http://www.pdffactory.com
Office 8K - 8 Buttons Wireless Optical Mouse
UK
e operates on two frequency channels. To prevent interference when
a different frequency channel should be
to change the frequency
Remove the battery cover from the mouse (see the following Inserting the
on the mouse to 1 or 2. (The frequency channel
Press the tab on the bottom of the mouse cover as shown here and remove
indicated on the battery
L
Selecting the Frequency Channel
The RF-Mous
using two RF Mice in close proximity,
used for each mouse. Refer to the following instructions
channel for your mouse:
1. Set the frequency channel (B) on the receiver to 1 or 2.
2.
Batteries section).
3. Set the frequency channel (L)
for mouse and receiver must be the same).
Inserting the Batteries
The RF-Mouse uses two batteries. Refer to the following to insert the batteries:
1.
the cover.
2. Insert the two batteries. (The correct polarity is
compartment casing.)
3. Replace the cover.
B
L
- 3 -
PDF 檔案以 "FinePrint pdfFactory Pro" 試用版建立 http://www.pdffactory.com
Loading...