Fimco LG-40-SS Assembly / Operation Instructions / Parts

5301335

MODEL NO. LG-40-SS

ASSEMBLY / OPERATION INSTRUCTIONS / PARTS

GENERAL INFORMATION

The purpose of this manual is to assist you in operating your
sprayer. Please read it carefully as it furnishes information
which will help you operate and maintain your sprayer.

WARRANTY / PARTS / SERVICE

ASSEMBLY

The sprayer is fully assembled at the factory. Hook up the
wiring to an existing 12 volt power source. The red wire of
the two wire set must be connected to the positive post on the
battery or the “Hot” connection on a switch or to the ammeter.
The brown wire may be grounded or connected to the
negative battery post.

OPERATION

The pump on the sprayer is factory set to shut off automati­cally at a maximum of 45 PSI. The handgun may be shut off
at any time when the pump is running. The pump will shut off
when there is no discharge from the handgun.

The pumping system draws solution from the tank and to the
pump. The pump forces the solution under pressure to the
handgun.

It is important to test the sprayer with plain water before
attempting actual spraying. This will enable you to check the
sprayer for leaks in the plumbing system.

1. Open tank lid and be sure the tank is clean and free of
foreign material. Fill the tank about half full with plain water.

Products are warranted for one year from date of purchase
against manufacturer or workmanship defects.

Your authorized dealer is the best source of replacement
parts and service. To obtain prompt, efficient service,
always remember to give the following information.

1. Correct part description and part number.

2. Model number of your sprayer.

3. Serial number of your sprayer.
Part number and descriptions can be obtained from the

illustrated parts list section of this manual. Whenever you
need parts or repair service, contact your distributor / dealer
first. For warranty work always take your original sales slip,
or other evidence of purchase date, to your distributor /
dealer.

TECHNICAL SPECIFICATIONS

• 40 Gallon Polyethylene Tank

• 12 Volt Diaphragm Pump - 3.8 G.P.M.

• Adjustable Pressure Range 0 - 45 P.S.I.

• 25 Foot Handgun Hose

• Pistol Grip Handgun

• Suction Line Filter

WARNING: Some chemicals will damage the pump valves
if allowed to soak untreated for a length of time. Always flush
the pump after use. Do not allow chemicals to sit in pump for
extended times of idleness. Follow chemical manufacturers
instructions on disposal of all waste water from the sprayer.

AFTER SPRAYING

After use, fill the sprayer part way with water, start the
sprayer and allow clear water to be pumped through the
plumbing system and out through the handgun. Use the
handgun to thoroughly wash all internal parts of tank and
tank cover.

WWW.FIMCOINDUSTRIES.COM

1000 FIMCO LANE • P.O. BOX 1700 • NO. SIOUX CITY, SD 57049
TOLL FREE: 800-831-0027 • TOLL FREE FAX: [phone]
Form No. 5004623 (850 11/05) Printed In U.S.A.

Page 1

Refill the tank about half full with plain water and use a
chemical neutralizer such as NUTRA-SOL or equivalent and
repeat cleaning instructions above. Flush the entire sprayer
with the neutralizing agent. Follow the chemical manufactur­ers disposal instructions of all wash and rinsing water.

WINTER STORAGE

Drain all water out of the sprayer paying special attention to

pump, valves, and spray gun. These items are especially
prone to damage from chemicals and freezing weather.

The sprayer should be winterized before storage by pump­ing a solution of RV anti-freeze through the entire plumbing.
Proper care and maintenance will prolong the life of the
sprayer.

Page 2