1
Design of the Watch
Thank you for purchasing this watch.
Please read this manual thoroughly before using the watch!
Hour
Hand
Stopwatch
Hour Hand
Small
Second Hand
Stopwatch
Minute Hand
Stopwatch
Second Hand
Minute
Hand
Date
Stopwatch
Start /Stop
[A]
N 1 2
Stopwatch
[B]
N: Normal
1: First Click
2: Second Click
Reset
FILActive
FAY001CH
www.fila.com/watch
User
MANUAL
FM-720.1
2
Specifications
• MIYOTA OS10
• Chronograph with date
• Stainless steel case and silicon strap
• 10 ATM
* These specifications might be changed without prior notice.
3
Date and Time Setting
3.1. - 2.
1. Pull out the crown to the first click.
2. Turn the crown counter-clockwise to the date desired.
3. Pull out the crown to the second click when the second hand
is at the 12 o’clock position. It will stop on the spot and rotate
the hour and minute hands by turning the crown.
4. Push the crown back in to the normal position in accordance
with a time signal. The small second hand begins to run.
NOTE
- Do not set the date hand between 9:00p.m. and 1:00a.m.
Otherwise, the day may not change properly. If it is necessary
to set the date during that time period, first change the time
to any time outside it, set the date and then reset the correct
time.
4
Using the Stopwatch
Standard Measurement
Start Stop
[A] [A]
[A] [A]
Time 2
Reset
[B]
Reset
[B]
N
1. Press [A] to start counting, press [A] to stop counting.
2. Press [B] to reset the stopwatch.
This stopwatch is able to measure and display time in 1/1
second united up to maximum of 11 hours 59 minutes 59
2N 1N 1
seconds.
Stopwatch will stop automatically after running continuously for
11 hours 59 minutes 59 seconds.
Accumulated Elapsed Time Measurement
Start
[A]
N
Time 1 + Time 2 = Accumulated Elapsed Time
1. Press [A] to start counting, press [A] to stop counting.
2. Press [A] to start continuously counting.
3. Press [A] to stop and review the accumulated elapsed time.
4. Press [B] to reset.
Note: Restart and stop the stopwatch can be repeated as many
times as necessary by pressing [A].
Time 1
Stop
[A]
Start Stop
5
Resetting Stopwatch Position Hands
If either of the stopwatch hands are not in the “0” position, reset
them according to the procedure below.
[A]
2N 1
[B]
1. - 3.
1. Pull out the crown to the second click.
2. Press [A] to set the stopwatch second hand to the “0”
position.
* The stopwatch second hand can be advanced rapidly by
continuously pressing button [A].
3. Once the hand been zeroed, reset the time and return the
crown to its normal position.
Note: Do not push crown to normal position while the stopwatch
second hand returns to zero position. It stops on the way when
crown are returned to normal position and its position is
recognized as zero position.
6
Care and Maintenance
• This watch contains electronic components. Never attempt
to open the case or remove the back cover.
• Avoid exposing the watch to extreme temperature,
chemicals which will damage the watch.
• Keep the watch away from the conditions of strong electric
field and static electricity.
• Avoid rough usage or severe impact. The watch is designed
to withstand impact under normal use. It is advisable to
subject it to severe impact or rough usage.
• Clean your watch occasionally with a soft moistened cloth
only. Avoid using chemicals, especially soap as the
waterproof gasket will corrode.
• Store the watch in a dry place when it is not in use.
8
Precautions for Water Resistance
All FILA watches are designed to withstand use as indicated on
the below chart.
Indication
Level of
resistance
3ATM
(30 meters)
5ATM
(50 meters)
10ATM
(100 meters)
• Water damage may occur if the push buttons are pressed
under water.
• Should water or condensation appear in the watch, please
check the watch immediately as corrosion of electronic
parts can occur inside the case.
* Always set the crown in the normal position.
Light spray
perspiration,
light rain, etc
Water-related use
Bathing,
etc
Swimming,
etc
9
Precautions for Battery
Battery Life
The battery in your FILA watch is estimated to last for 2 years.
Battery Replacement
If the watch is out of battery, you are recommended to go to the
authorized FILA service center for correct battery replacement in
order to retain a valid warranty and avoid any damage on the
water resistance function.
WARNING!
Always keep watch batteries away from children. If swallowed,
contact a doctor immediately. Batteries contain chemical
substances. They should be disposed of properly according to
local regulations.
7
Precautions for Straps
• Exposure to water often makes a strap fragile and it may
soon tear.
• Don’t apply perfume or moisturizers around your wrist as
the chemicals can erode the metal, leather and plastic of
watch straps.
• The strap’s condition will depend on the owner’s wearing
habits as well as the climate of the place where the person
lives. An original replacement on straps is possible to be
re-ordered through an authorized service center.
• PU straps are usually very hardwearing, please wash them
with mild soapy water only.
• There may be discoloration for light color and transparent
straps after normal wear for some time.
• In case if there is any severe or persistent skin reaction, such
as severe redness, itching, rash or hives, you should stop
wearing this watch, and consult your doctor.
FILA™ is trademark of FILA Luxembourg and
used under licence by LONGITUDE LIMITED.
Loading...