Field Controls 46206700, DI to CK User Manual

CONTROL KIT ADAPTER KIT

7/16” 24NF

Model: DI to CK

1/4” Tube Sleeve

1/4” Tube Fitting

5 Feet – 1/4” Tubing

Tube Nut

Locking Nut

ITEMS INCLUDED IN KIT

1) 7/16” 24NF Locking Nut

1) Tube Nut

1) 1/4” Tube Sleeve

1) 1/4” Tube Fitting
5 Feet – 1/4” Tubing

INSTALLATION

1. Remove the plug button on the side of the draft inducer housing. (See
Figure 1)

2. Insert the tubing fitting through the hole and fasten it with the fitting
nut. (See Figure 2)

PRESSURE SWITCH SENSING TUBE

1. Connect the supplied 1/4 inch aluminum tubing to the tubing fitting.

2. Route the tubing to the CK-Kit junction box and connect the tubing to
the pressure switch. (See Figure 3) When routing the tubing, avoid
kinking the tubing by bending the tubing too sharply.

3. For tubing distance greater than 5 ft. and less than 30 ft., use 1/4 in.
O.D. copper, aluminum or plastic tubing to avoid contact with any hot
surfaces.

4. Refer to the CK-Kit and the DI-inducer installation instructions for
wiring and setting systems air flow.

Figure 1

Figure 2

Figure 3

P/N 46206700 Rev A 02/01