Fiamma VERONA Installation And Operation Instructions Manual
MADE IN CONNECTICUT !
VERONA by FIAMMA Manufacturing llc
If for any reason, you cannot follow these instructions, FOR
Please hire a plumber or Qulified Installer
not use this product if you cannot follow these instructions.
The Verona Burner System is designed, and intended, for
installation in an existing approved, fully vented, wood-burning
fireplace, which includes gas hook-up. Gas Control Valve units
may be fueled by, either Natural Gas or Liquid Propane. Liquid
Propane must be orderd as such, DO NOT Connect the Unit with
any fuel other than is intended !
ANY REASON WHATSOEVER
DO NOT INSTALL IN A WOOD BURNING STOVE
NEVER OPERATE WITH CLOSED GLASS DOORS !
These instructions are intended as a general guide and do not
supersede national or local codes in any way. Authorities
having jurisdiction should be consulted before installation.
Installation and provision for combustion and ventilation air
must conform to the National Fuel Gas Code, ANSI
Z223.1/NFPA 54, or CAN/CGA-B149.1, Natural Gas
Installation Code, or CAN/CGA-B149.2, Propane Installation
Code.
.
GENERAL INFORMATION
!!! IMPORTANT !!!
Read these instructions carefully before installing or operating
this gas appliance. These instructions should be left with the
homeowner for future reference.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
If the information in this manual is not followed exactly, a fire or
explosion may result causing property damage, personal injury
or loss of life.
Gas Burner System
³3/($6(´ do
!!! WARNING !!!
LLC.
WHAT TO DO IF YOU SMELL GAS:
< Do not try to light any appliance.
< Do not touch any electrical switch; do not use
any phone in your building.
< Immediately call your gas supplier from a
QHLJKERU¶VSKRQH. Follow the gas sXSSOLHU¶V
instructions.
< If you can not reach your gas supplier, call the
fire department.
Do not store combustible materials or use gasoline
or other flammable vapors and liquids in the vicinity
of this or any other appliance.
Installation and service must be performed by a:
Qualified technician, service agency, or the gas
supplier.
Your unit was test fired and Inspected prior to shipment.
Any discoloration on the Burner or pilot is due to the test fire
!!! WARNING !!!
This appliance must be installed only in a solid-fuel burning
fireplace with a working flue and constructed of noncombustible materials. This unit is NOT for use with solid fuel.
Solid fuels shall NOT be burned in a fireplace where a
decorative appliance is installed.
!!! DANGER !!!
NEVER OPERATE THIS APPLIANCE WITH
1
FIREPLACE GLASS DOORS CLOSED !
SAFETY INFORMATION
<
<
<
<
<
<
<
<
<
Any safety screen or guard removed for servicing an appliance must
be replaced prior to operating the appliance.
During manufacturing, fabrication, and shipping, various components
of this appliance are treated with certain oils, films, or bonding agents.
These chemicals ARE NOT harmful, but may produce annoying smoke
and smells, as they are burned off, during the initial operation of the
appliance. This may possibly cause headaches, and eye or lung
irritation. This is a normal and temporary occurrence. The initial
break-in period should last three ( 3 ) to four ( 4 ) hours. During this
period, provide maximum ventilation by opening a window or door, to
allow odors to dissipate. Any odor remaining after this initial break-in
period, will be slight and will disappear with continued use.
DO NOT USE SAND OR ANY OTHER GRANULAR
MATERIAL AS A BURNER MEDIUM! USE ONLY THE
APPROVED MEDIUM, EITHER PROVIDED, OR AS AN
APPROVED ACCESSORY.
PROPER CLEARANCES FROM COMBUSTIBLE
CONSTRUCTION AND MATERIALS MUST BE MAINTAINED
FROM ALL SIDES, TOP, AND BOTTOM OF THIS
APPLIANCE.
THIS APPLIANCE SHOULD NEVER BE PLACED NEAR
ANY COMBUSTIBLE SURFACE.
THIS APPLIANCE SHOULD NEVER BE PLACED UNDER
ANY COMBUSTIBLE CONSTRUCTION OR MATERIALS.
NEVER PLACE ANY COMBUSTIBLE MATERIAL WITHIN
24" OF THE
WARNING
manual, prior to operation.
WARNING: Fuels used in gas or oil ± fired appliances, and
the products of combustion of such fuels, contain chemicals
known to the State of California to cause cancer, birth
defects, and/or other reproductive harm. This warning is
issued pursuant to California Health & Safety Code Sec.
25249.6.
While this appliance is not in use, the gas must be turned off
at the gas supply.
DO NOT
GAS FITTING WHILE THIS APPLIANCE IS IN
OPERATION.
NEVER
while in operation.
NEVER
appliance.
NEVER
decorative gas appliance.
NEVER
DO NOT
appliance.
: Follow all gas leak check procedures in this
ATTEMPT TO DISCONNECT THE GAS OR ANY
leave this decorative gas appliance unattended
allow children to operate this decorative gas
place hands or fingers on the front edge of this
use liquid propane gas in a natural gas unit.
use solid-fuel or lighter fluid in any decorative gas
!!! WARNING !!!
FIREPLACE ENCLOSURE.
2
!!! WARNING !!!
The damper clamp, must be installed, in a manner, which will
maintain the minimum permanent damper vent opening at all
times. SEE FIGURE 1. See the Decorative Hearth System
Specifications on page 3.
!!! WARNING !!!
The State of Massachusetts requires that the chimney flue
damper, when used with decorative gas appliances, be welded
open or completely removed. In the Commonwealth of
Massachusetts, this appliance must be installed by a licensed
plumber or gasfitter.
!!! WARNING !!!
Improper installation, adjustment, alteration, service or
maintenance, can cause property damage, personal injury or
ORVVRIOLIH5HIHUWRWKHRZQHU¶VLQIRUPDWLRQPDQXDOSURYLGHG
with this appliance. Installation and service, must be
performed, by a qualified installer, service agency or the gas
supplier.
HIGH ALTITUDE DERATE
In the U.S.A., input BTU shall be de-rated 4% ( 1 orifice size )
per 1000 ft. for altitudes above 2000 ft.. In Canada, input BTU
shall be de-rated 10% ( 2 orifice sizes ) at altitudes from 2000
ft. to 4500 ft..
A Front Width = Minimum 6" larger than unit size
B Center Width = Not Less than unit size
C Depth = All Verona Burners are 8.5 inches deep
D Height = Minimum 16"
3
Flue Damper Clamp NOT OPTIONAL !
FIGURE 1
INSTALLATION
LOCATION
This appliance, must be installed only in a solid-fuel burning
fireplace, with a working flue, and constructed of
noncombustible materials.
!!! IMPORTANT !!!
Before installing this appliance, have the fireplace and
chimney, professionally cleaned, to remove any ashes, soot,
creosote, or other obstructions. Perform this cleaning
annually, after installation.
!!! IMPORTANT !!!
Seal any fresh air vents or ash clean-out doors located on the
floor or wall of the fireplace. If this is not performed, drafting
may cause pilot outage or sooting. Use a heat-resistant
sealant; DO NOT seal the chimney flue damper.
!!! WARNING !!!
Gas supply system must be installed in accordance with the
U.S. National Fuel Gas Code.
This appliance and its individual shut off valve must be
disconnected from the gas supply piping system during any
system pressure test in excess of ! PSI ( 3.5 KPA ).
Use a system manual shut off valve to shut off the gas supply
to this gas appliance before continuing with
procedures.
installation
FIGURE 2
VERONA 3
BURNER SYSTEM
FRONT VIEW
NEVER OPERATE UNIT WITHOUT MEDIA ON BURNER
The Burner May warp and will not be covered under warranty.
FIGURE 3 ±
VERONA
BURNER SYSTEM
NOTE: Verona 23" and 30 " are a single Burner.
Verona 42" is A double Burner system, All
Co ntrols and functions are the same.
WHEN INSTALLING THE APPLIANCE, DO NOT
VERONA 42
OBSTRUCT THE FLOW OF COMBUSTION AND VENTILATION AIR.
BURNER SYSTEM FRONT VIEW
4
Loading...